Prestige 652H/HW

 

 

 

Table 1 Prestige Rear Panel Description

 

 

 

 

 

 

LABEL

DESCRIPTION

 

 

 

 

 

 

CON/AUX

Only connect this port if you want to configure the Prestige using the SMT via console port or

 

 

switch

set up a backup WAN connection; see your User’s Guide for details.

 

 

CON/AUX port

Set this switch to the “CON” side to use the CON/AUX port as a console port for local device

 

 

 

 

 

 

configuration and management. Connect the 9-pin male end of the console cable to the console

 

 

 

port of the Prestige and the other end to a serial port (COM1, COM2 or other COM port) on your

 

 

 

computer. Your computer should have a terminal emulation communications program (such as

 

 

 

HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow

 

 

 

control and 9600 bps port speed.

 

 

 

Set this switch to the “AUX” side to use the CON/AUX port as an auxiliary dial-up WAN

 

 

 

connection. Use the included CON/AUX converter, with the console cable to connect the

 

 

 

CON/AUX port to your modem or TA.

 

 

RESET

You only need to use this button if you’ve forgotten the Prestige’s password. It returns the

 

 

 

Prestige to the factory defaults (password is 1234, LAN IP address 192.168.1.1 etc.; see your

 

 

 

User’s Guide for details).

 

 

 

 

 

2.2 Inserting a PCMCIA Wireless LAN Card

Use a ZyAIR series wireless LAN PCMCIA card to add optional wireless LAN capabilities. Step 1. Turn off the Prestige.

Never insert or remove a wireless LAN card when the Prestige is turned on.

Step 2. Locate the slot labeled Wireless LAN on the Prestige.

Step 3. With its pin connector facing the slot and the LED side facing upwards, slide the ZyAIR wireless LAN card into the slot.

Never force, bend or twist the wireless LAN card into the slot.

Step 4. Turn on the Prestige. The WLAN LED should turn on.

2.3 The Front Panel LEDs

4