ZyAIR B-5000 Quick Installation Guide

Step 2. Run the Ethernet cable from the DATA IN port (on the front of the inline power injector) to the Ethernet port on a computer.

Figure 15 - Ethernet Cable With Inline power injector

This connection is required for setting up initial configuration information. After configuration is completed, this cable will be removed, and then you should run an Ethernet cable from the Data In port (on the front of the Inline power injector) to the LAN connection (such as to a hub, bridge or directly into a patch panel).

Step 3. Connect the MIL-C-5015 style Ethernet connector into the special Ethernet port on the bottom of the ZyAIR.

Figure 16 - MIL-C-5015 Style Ethernet Connector

15