Chapter 5 Initial Setup Example
XGS-4528F User’s Guide
64
"The VLAN Group ID field in this screen and the VID field in the IP Setup
screen refer to the same VLAN ID.
3Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to
configure port 1 to be a permanent member of the VLAN only.
4To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames
properly, clear the TX Tagging check box to set the Switch to remove VLAN tags
before sending.
5Click Add to save the settings to the run-time memory. Settings in the run-time memory
are lost when the Switch’s power is turned off.
5.1.4 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames
are forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames
received on that port get sent to VLAN 2.
Figure 22 Initial Setup Network Example: Port VID
1Click Advanced Applications
and VLAN in the navigation
panel. Then click the VLAN
Port Setting link.
2Enter 2 in the PVID field for
port 1 and click Apply to save
your changes back to the run-
time memory. Settings in the
run-time memory are lost when
the Switch’s power is turned off.
EXAMPLE