Module and Fan Installation
Tools
Tools
The following tools are recommended to install, configure, operate, and maintain the Broadmore 1750:
#1 flathead screwdriver (for cover and fan tray removal/installation)
Dual jeweler’s flathead/Phillips screwdriver
ESD wrist strap
Other standard installation tools as desired.
Remove Front Chassis Cover
Only the front cover must be removed to install the fan tray.
1.Loosen captive screws securing the front cover and set the cover aside.
2.Connect an ESD wrist strap to the front or rear ESD connector and follow standard ESD procedures while handling unit components.
WARNING! USE ESD PRECAUTIONS: WEAR AN ESD GROUNDING STRAP WHILE HANDLING ANY MODULES OR ACCESSING THE INSIDE OF THE BROADMORE 1750. FAILURE TO FOLLOW ESD PROCEDURES MAY DAMAGE SENSITIVE COMPONENTS AND VOID THE WARRANTY.
Fan Tray Installation
1.The fan tray installs from the front, directly below the modules. Fan tray guides are provided on each side of the chassis. Slide the fan tray into the guides and firmly push it into place so that connectors totally seat with the midplane.
2.Tighten the two front panel retaining screws using a flathead screw driver.
Broadmore 1750 - Release 4.6 |
