4.3.2 Ports
Ports page is used to change the setting for LAN ports. You can set or reset the following items. All of them are described in detail below.
Port | It displays current network interface. |
Link | It displays current connection status. Green light means the |
| LAN connection is successful. |
Current | It displays current speed that the router uses. |
Speed Configured | It can set the speed and duplex of the port. You can use the drop |
| down list to choose the required speed for the router. If you |
| have no idea in configuring speed, simple use the default setting, |
| Auto. |
Flow Control | If flow control is enabled by checking Configured box, both |
| parties can send PAUSE frame to the transmitting device(s) if |
| the receiving port is too busy to handle. If not, there will be no |
| flow control in the port. It drops the packet if too much to |
| handle. |
| Current Rx: indicates whether pause frames on the port are |
| obeyed. |
| Current Tx: indicates whether pause frames on the port are |
| transmitted. |
Maximum Frame | This module offers 1518~9600 (Bytes) length to make the long |
| packet for data transmission. |
Excessive Collision Mode There are two modes for you to choose when excessive collision happened in
136 | Vigor2750 Series User’s Guide |
