Husqvarna CRT1350LS Safety Rules, Training, Preparation, Operation, Maintenance and Storage

Page 2

SAFETY RULES

Safe Operation Practices for Walk-Behind Powered Rotary Tillers

TRAINING

Read the Owner’s Manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction.

Keep the area of operation clear of all persons, par- ticularly small children, and pets.

PREPARATION

Thoroughly inspect the area where the equipment is to be used and remove all foreign objects.

Disengage all clutches and shift into neutral before starting the engine (motor).

Do not operate the equipment without wearing adequate outer garments. Wear footwear that will improve footing on slippery surfaces.

Handle fuel with care; it is highly flammable.

Use an approved fuel container.

Never add fuel to a running engine or hot engine.

Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors.

Replace gasoline cap securely and clean up spilled fuel before restarting.

Use extension cords and receptacles as specified by the manufacturer for all units with electric drive motors or electric starting motors.

Never attempt to make any adjustments while the engine (motor) is running (except where specifically recommended by manufacturer).

OPERATION

Do not put hands or feet near or under rotating parts.

Exercise extreme caution when operating on or cross- ing gravel drives, walks, or roads. Stay alert for hidden hazards or traffic. Do not carry passengers.

After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, thoroughly inspect the tiller for any damage, and repair the damage before restarting and operating the tiller.

Exercise caution to avoid slipping or falling.

If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

Stop the engine (motor) when leaving the operating position.

Take all possible precautions when leaving the machine unattended. Disengage the tines, shift into neutral, and stop the engine.

Before cleaning, repairing, or inspecting, shut off the engine and make certain all moving parts have stopped. Disconnect the spark plug wire, and keep the wire away from the plug to prevent accidental starting. Disconnect the cord on electric motors.

Do not run the engine indoors; exhaust fumes are dangerous.

Never operate the tiller without proper guards, plates, or other safety protective devices in place.

Keep children and pets away.

Do not overload the machine capacity by attempting to till too deep at too fast a rate.

Never operate the machine at high speeds on slippery surfaces. Look behind and use care when backing.

Never allow bystanders near the unit.

Use only attachments and accessories approved by the manufacturer of the tiller.

Never operate the tiller without good visibility or light.

Be careful when tilling in hard ground. The tines may catch in the ground and propel the tiller forward. If this occurs, let go of the handlebars and do not restrain the machine.

MAINTENANCE AND STORAGE

Keep machine, attachments, and accessories in safe working condition.

Check shear pins, engine mounting bolts, and other bolts at frequent intervals for proper tightness to be sure the equipment is in safe working condition.

Never store the machine with fuel in the fuel tank inside a building where ignition sources are present, such as hot water and space heaters, clothes dryers, and the like. Allow the engine to cool before storing in any enclosure.

Always refer to the operator’s guide instructions for important details if the tiller is to be stored for an ex- tended period.

- IMPORTANT -

CAUTIONS, IMPORTANTS, AND NOTES ARE A MEANS OF ATTRACTING ATTENTION TO IMPORTANT OR CRITICAL INFORMATION IN THIS MANUAL.

IMPORTANT: USED TO ALERT YOU THAT THERE IS A POSSIBILITY OF DAMAGING THIS EQUIPMENT.

NOTE: Gives essential information that will aid you to bet- ter understand, incorporate, or execute a particular set of instructions.

Look for this symbol to point out im- portant safety precautions. It means CAUTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.

CAUTION: Always disconnect spark plug wire and place wire where it can- not contact spark plug in order to pre- vent accidental starting when setting up, transporting, adjusting or making repairs.

WARNING

The engine exhaust from this product con- tains chemicals known to the State of Cali- fornia to cause cancer, birth defects, or other reproductive harm.

2

Image 2
Contents CRT1350LS Training Safety RulesMaintenance and Storage PreparationTable of Contents OPERATOR’S Position See Fig AssemblyTools Required for Assembly Install Handle See Figs , 4, Unpacking Carton See FigRemove Tiller from Crate Attach Clutch Cable See FigConnect Shift ROD See Fig Check Tire PressureKnow Your Tiller Meets Ansi Safety RequirementsOperation HOW to USE Your Tiller Check Engine OIL Level See Before Starting EngineTo Transport ADD GasolineCultivating Tine Shear PinsTilling Hints Lubrication Chart MaintenanceMaintenance Schedule General RecommendationsEngine AIR Filter See FigMuffler CleaningCooling System See Fig Spark PlugTire Care Service and AdjustmentsTiller Ground Drive Belt Adjustment See Fig To Replace Ground Drive Belt See FigTine Replacement See Figs , 25 To Adjust Carburetor Fuel System StorageOther Engine OILTroubleshooting Points Repair Parts Handle AssemblyMAINFRAME, Left Side MAINFRAME, Right Side Transmission Tine Shield KEY Part NO. NO. DescriptionTine Assembly Decals Service Notes 12.10.09 AP/SR

CRT1350LS specifications

The Husqvarna CRT1350LS is a robust and dynamic ride-on mower designed for residential and commercial mowing needs. It combines power and precision, making lawn maintenance an effortless task. With a premium design and advanced technology, this mower stands out in the competitive landscape of lawn care equipment.

One of the standout features of the CRT1350LS is its powerful 13.5 HP engine. This engine not only delivers remarkable performance but also ensures reliability and longevity. The mower is designed with a durable steel cutting deck, measuring 50 inches, which allows for efficient mowing of larger areas. The high-capacity deck design ensures that grass clippings are evenly distributed, providing a professional-looking finish every time.

The cutting height can be easily adjusted, offering five different settings ranging from 1.5 to 4 inches. This versatility allows users to customize their mowing experience, accommodating different grass types and conditions. Furthermore, the CRT1350LS features an integrated mulching system that finely chops grass clippings, returning them to the lawn to provide natural nutrients and reduce waste.

Husqvarna has incorporated advanced technologies into the CRT1350LS to enhance user experience. The model is equipped with a comfortable, ergonomic seat designed for optimum comfort during extended mowing sessions. Additionally, the intuitive control layout ensures that all necessary functions are easily accessible, allowing for effortless operation.

Another notable characteristic of this mower is its hydrostatic transmission system. This technology provides seamless speed changes without the need for gear shifting, enabling the operator to maintain speed while tackling uneven terrain. The CRT1350LS also has a tight turning radius, making it easy to maneuver around obstacles in the yard.

For safety, the CRT1350LS includes features such as an automatic blade brake system that engages when the operator leaves the seat, minimizing the risk of accidents. The robust construction, combined with easy-to-access maintenance points, ensures that upkeep is simple and effective, extending the life of the mower.

In summary, the Husqvarna CRT1350LS is an exceptional ride-on mower that excels in performance, comfort, and technology. Its powerful engine, adjustable cutting height, and user-friendly design make it an ideal choice for maintaining pristine lawns, offering both residential and commercial users the tools they need for effective lawn care.