LUBRICATION
3. Engine Oil
Changing the Engine Oil
The engine oil shall be changed for the first time after 50 hours of operation. Thereafter, it should be changed every 150 hours.
WARNING!
The engine and the exhaust system, become very hot during operation.
Risk for burns if touched.
Allow engine and exhaust sytem to cool at least two (2) minutes.
1.Place the machine on a flat surface.
2.Place a container under the engine drain plug.
3.Remove the dipstick and open the drain plug.
4.Allow the oil to run out into the container.
5.Install and tighten the oil drain plug.
6.Replace the oil filter if necessary.
7.Fill with new engine oil in accordance with Checking the Oil Level.
8.Start the engine. Run it for a few seconds. Stop and
Checking the Oil Level
Check the oil level in the engine when the machine is standing level and the engine is stopped.
Remove the dipstick, wipe it clean, and then replace it.
Take the dipstick out again and read the oil level.
IMPORTANT INFORMATION
Used engine oil is a health hazard and must not be disposed of on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location.
Avoid skin contact; wash with soap and water in case of spills.
Oil drain plug
Remove the dipstick