LUBRICATION
12. Belt Adjuster, Hydraulic Pumps
Lubricate using a grease gun, one zerk, until the grease squeezes out.
Use only good quality molybdenum disulphide grease.
Grease from
a good quality.
IMPORTANT INFORMATION
Use minimal lubrication and remove excess lubricant so that is does not come into contact with belts or belt pulley drive surfaces.
13. Changing the Oil Filter
1.Drain the engine oil in following the procedure in the section, Engine Oil/ Change Engine Oil.
2.Disassemble the oil filter. If necessary, use a filter remover.
3.Partially fill the new filter with oil.
4.Wipe new, clean engine oil onto the seal for the new filter.
5.Mount the filter by hand with + 3/4 turn.
6.Run the engine warm, then check that there are no leaks around the oil filter seal.
7.Check the oil level in the engine, top off if necessary.
Lubricating the belt adjuster
Changing the oil filter