Husqvarna BZ 34, BZ 27 manual Throttle Cable, Lever Bearings, Front Wheel Mount

LUBRICATION

The oil level shall lie between the markings on the dipstick. If the level is approaching the ”ADD” mark, top up the oil to the ”FULL” mark on the dipstick.

Never fill above the ”FULL” mark.

The oil is filled through the hole for the dipstick.

Use engine oil SAE 30 or SAE 10W-30 or, alternately, 10W/40, class CF–4, CI-4 (over +32 °F/0 °C).

Over +68 °F /+20 °C SAE 40 can be used.

Use engine oil SAE 5W-20, class CF–4, CI-4 (under +32 °F/0 °C).

The engine holds 3.5qt/3.3 liters of oil including the filter.

4. Throttle Cable, Lever Bearings

Lubricate the cable ends by the lever with an oil can. Move the controls to the end points and lubricate again.

The throttle cable is also lubricated by the control when the control console is removed.

5. Front Wheel Mount

Lubricate with a grease gun, one zerk for each wheel mount, use 10 pumps of the grease gun at the recommended service intervals. Use only good quality lithium based grease.

Use only good quality molybdenum disulphide grease.

8009-159

The dipstick markings

8009-140

Engine oils

8011-605

Throttle and choke cables by the carburetor

English-58