Husqvarna 15V2 AWD manual Service position for the cutting unit, Placing in the service position

Page 28

Maintenance

3Loosen the spring (4) that tensions the V-belt and pry off the belt.

Simply reverse the procedure to ﬁt the new belt.

Service position for the cutting unit

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.

Placing in the service position

1Position the machine on ﬂat ground. Apply the parking brake. Adjust the cutting unit to the lowest cutting height and lower the cutting unit.

2Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood).

3Remove the two support wheels from under the front hood.

4Fit the support wheels on either side of the rear of the cutting unit.

WARNING! Wear protective glasses when

!dismantling the cutting unit. The spring which tensions up the belt may break and cause personal injury.

5Disengage the spring for the drive belt tensioning wheel. Rider 15V2

Rider 15V2 AWD

6Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut.

28 – English

Image 28

Contents Rider 15V2 Rider 15V2 AWD Contents Pre-delivery service Service journalAfter the ﬁrst 8 hours Introduction Dear CustomerDriving and transport on public roads TowingGood service Serial NumberKEY to Symbols SymbolsKEY to Symbols Safety Instructions Safety instructionsInsure your Rider General useDriving on slopes This is what you doMaintenance ChildrenTransport What is WHAT? Location of the controlsPresentation Cutting height adjustment lever Exercise care and refuel outdoors see safety instructionsLifting lever for the cutting unit SeatBefore starting DrivingStart the engine Starting the engine with a weak battery Connecting the jump leadsDriving the Rider Remove the cables in the reverse orderStop the engine Cutting tipsOther objects which can be thrown out by the blades Release lever Rider 15V2 AWD Release leverRelease lever Rider Maintenance Maintenance scheduleChecking and adjusting the steering wires CleaningRemoving of the machine hoods Adjusting the parking brake Rider Adjusting the parking brake Rider 15V2 AWDChecking and adjusting of throttle wire Can result in reduced braking abilityChecking and adjusting the choke wire Replacement of fuel ﬁlterReplacing the air ﬁlter Cool before starting to replace the air ﬁlterCheck the level of the battery acid Checking the fuel pump’s air ﬁlterIgnition system Replacing the spark plugCheck the safety system When the engine is running. Mind your ﬁngers Main fuse Checking the tyre pressure Checking the engine’s cooling air intakeRemoving the cutting unit Trapping your handChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitReplacing the cutting unit belts Service position for the cutting unit Placing in the service positionChecking the blades Restoring from service positionRemoving the BioClip plug Lubrication Checking the engine’s oil levelChanging the oil ﬁlter Replacing the engine oilChecking the transmission oil level Lubricating the belt adjusterGeneral lubrication Troubleshooting schedule Problem ProcedureService StorageWinter storage GuardTechnical data EC-declaration of conformity Applies to Europe only 1150312-26 ´z+R?6¶6@¨ ´z+R?6¶6@¨