Assembly log side-rest Assembly log bed | Husqvarna M7 specification

Assembly: log side-rest

Assembly: log bed

8
A
	C
	11
B	12
8
	10
	9
	D
12

(7)Fit the log side-rest. make sure that the measuring scales are both facing in torwards the center of the mill so that operator can read both scales from the center position.(2 x M6x20 bolts, 2 x M6 collar nuts)

(8)Place the plastic slide rail on the log bed. Fit the longer (A) scale against the plastic rail on the right log bed and the shorter

(B) against the side of the left log bed. Do not tighten the bolts all the way. (2 x M6x30 allen head bolts, 2 x M6 collar nuts)

(9)Fit the ratchet bar stop plate under the lifting beam. (2 x M6x25 allen head bolts)

(10)Fit the line pulleys. (1 x M6x60 self-tapping bolt) Apply some pressure while driving it in.

(11)Fit the log support on the lifting beam. As the bolts will be hard to screw through the holes, use an Allen wrench to pull the log support down to the lifting beam. After app. 20 hours of use, these bolts will need to be retightened. (4 x M8x30 self-tapping allen head bolts, 4 x M8 collar nuts)

(12)Fit the rachet bar by threading the adjustment bolt

(D) through the ratchet bar stop plate and screwing on the nut. Do not tighten. Place the bar in the track of the lifting beam and tighten the adjusting nut on the bar. (1 x M10x40 bolt, 1 x M10 nut)