Assembly: frame
A |
2 |
1 |
3 |
4 |
4 |
The right and left leg units of the frame are assembled in the same way. The bolts listed below are for one leg unit.
(1)Fit the horizontal beam to the short leg using the corner fitting. Be careful not to damage the bevelled faces before assembly. (4 x M6x20 bolts, 4 x M6 collar nuts)
(2)Fit the horizontal beam to the long leg. The scale plate is fitted to the long leg using the two lower bolts.
Tighten all four bolts loosely to allow the beams
to move somewhat in relation to each other. (4 x M6x20 collar bolts, 4 x M6 collar nuts)
(3)Fit the angle fitting to the long leg and to the underside of the horizontal beam. First tighten the four bolts on the angle fitting loosely, gradually tightening them all the way. In this way the frame will be set at exactly 90°. (4 x M6x20 collar bolts, 4 x M6 collar nuts)
Finally tighten the bolts between the horizontal beam and the long leg. (2)
(4)Fit the sawmill feet, turning them so that the holes in the foot and the leg form a cross and that they lie correctly in the leg tracks. (4 x M8x25 allen head bolts, 4 x M8 nuts, 4 x M8 washers)
(A) Assemble the pulley, see picture. (1x M6 collar nut)
10