Assembly spiked log grip with guard

Assembly: spiked log grip with guard

	31
	32
28	29
	29
30
	29
	30

(28)Screw the handle with a washer on the threaded rod for the log grip carriage. (1 x M6 washer)

(29)Insert the bolts and screw on square nuts in the same way as when the chain-saw carriage was assembled (see page 17). (4 x M6x16 bolts, 4 x M6 square nuts)

(30)Fit the sliding rails under the plate so that the square nuts fit into the slide rail tracks.

(31)Center the guard, log grip and plastic spacer over the holes in the plate. The spacer should be turned so it extends as far as possible behind the grip. Thread the bolts through the holes and tighten. (2 x M6x40 bolts, 2 x M6 washers, 2 x M6 nuts)

(32)Thread the chain-saw feed line holder bolt through the spacer and fit on the plate. (1 x M6x25 bolt, 1 x M6 nut)

The holder bolt can be fitted in one of two holes depending on whether a petrol or an electric saw is being used. The picture illustrates set-up for a petrol saw. Make a loop on the feed line and place it over the spacer.