Husqvarna M7 manual Siting, Direction

Siting

Min. 0.5 m (1.6 ft)

The M7 WoodWorkers Mill	When setting up the M7	When bolting the M7 to a
may not tilt more than 5 °	directly on the ground:	concrete floor, asphalt
from the horizontal in any		surface or similar, rigid surface,
direction.	The surface must firm and	a rubber underlay should be
	level enough that driving a	placed under each foot in order
The saw may tip over if	normal car on it would not be a	to prevent vibration damage to
the tilt is greater. The unit	problem.	the sawmill. Use a reliable
may not be operated		fastening system between
unless the feet are faste-	Fit a board under each pair	the feet and the surface.
ned to the floor.	of legs using two M6 bolts
	for each foot. The boards must
The carriage may slide	be of good quality, at least
off the guide rail if the tilt	50x150 mm (2”x 6”) and at least
is greater.	2 m (6.5 ft) long. The boards
While the goal is to have the M7	must extend at least 0.5 m
	(1.5 ft) beyond the long legs.
WoodWorkers Mill fully level,
any tilt, however slight, must not
be away from the operator as
this can cause the logs to slide
off or lie at an angle.

19