Assembly: chain-saw
26 |
25 |
(25)Fit the Logosol extender nuts through the
ensure that the saw cover will not extend too far. However, this is relatively unusual.) Screw the
(26)Fit the chain guard support on the two arms of the chain- saw plate so that the chain guard sits app. 4 cm (1 1/2”) from the tip of the guide bar. (2 x M6x40 bolts, 2 x M6 collar nuts)
(27)Push the assembled carriage onto the guide rail with the guide bar facing the log beds.
Check that the carriage moves easily on the guide
rail. If not, loosen the eight bolts holding the sliding rails, move the carriage back and forth and retighten the eight bolts. If this is insufficient, check the plastic slide rails for damage.
27 |
17 |