Hustler Turf Z4 manual Storage, Product Literature, Preparation of engine for storage

Page 35

STORAGE

When storing the unit at the end of the mowing season, the following steps should be taken to ensure readiness for the next mowing season.

1.Remove all grass, dirt, and trash from tractor and cutting units.

IMPORTANT: Wash the machine with a mild detergent and water. Do not pressure wash the machine. Avoid excessive use of water

Clean tractor and mower and touch up all scrapes with touch-up paint.

2.Replace air filter element.

3.Check thoroughly for any worn or damaged parts that need replacing and order them from your dealer.

4.Block tractor up so weight is off tires. Check tire pressure and inflate to proper operating pressure.

NOTE: Do not deflate tires.

5.Perform separate engine and battery preparation as listed below.

6.Store tractor in a clean, dry place.

Preparation of engine for storage

When engine is to be unused for long periods, proceed as follows:

1.Run engine for a minimum of 15 minutes.

2.Drain oil from crankcase while engine is still warm.

3.Refill with fresh oil of proper viscosity.

4.Drain fuel tanks.

5.Remove and replace fuel filter.

6.Clean exterior surface of engine. Spread a light film of oil over any exposed metal surfaces of engine that are subject to corrosion.

7.Check oil filler cap and fuel tank cap to make certain they are securely in place.

Preparation of battery for storage

When the machine is to be unused for long periods, it is best to disconnect the batteries and remove them from the unit. At this time perform the following battery maintenance:

1.Remove the battery from machine

2.Clean battery, terminals and cable connectors

3.Charge the battery, if necessary

4.Store battery in a cool, dry place (do not expose to freezing temperatures)

5.Always keep the battery fully charged. (Especially

important to prevent battery damage when the temperature is below 32oF.)

New season preparation

Before starting the tractor following post season storage, the following servicing is required:

1.Clean tractor, removing trash and dirt accumulation.

2.Check engine oil, hydraulic oil and coolant levels.

3.Fill fuel tanks with fresh fuel. Bleed fuel system as outlined in Maintenance section. Run machine at half speed for 5 minutes, checking operation of steering control lever. Stop engine and check for oil leaks, loose fittings and so forth.

WARNING: At start of new season always check that fresh oil and coolant have been added to machine. If oil and coolant are drained at season’s end and not replaced, engine damage will result.

4.Tighten any bolts that have loosened and make sure all hair pins, cotter pins and clevis pins are in place.

5.Install all safety shields and review safety precautions listed in this manual.

6.Check and inflate tires to 8-12 psi (55-83 kpa).

7.Install fully charged batteries and attach the battery cables.

PRODUCT LITERATURE

If you would like to view or print a copy of the Hustler Z4 product manuals go online to www.hustlerturf.com and click on the MANUALS button.

5-2

602223_0609

Page 34 Page 36
Image 35
Page 34 Page 36
Contents Page General Information 6022230609 What is Covered by this Warranty Disclaimer of Warranty Safety and Instruction Decals Safety PrecautionsPart Part Number Part Number BJE OFF International SymbolsSlope Guide 6022230609 Operation OperationSafe Operating Practices Slope Operation Using a rampControls Safety start interlock systemChildren Control PanelEngine starting Check tractor safety start interlock system daily, prior toTorque values are given below Stopping the engineMoving tractor with stalled engine Roll Over Protective StructurePossible damage to the Rops Driving the tractorDirection of arrows indicate direction of tractor movement Front of Tractor Faces this DirectionTractor towing Operating suggestionsThree point turn Ve oAnti-scalp wheels Deck cutting height adjustmentMower deck operation 6022230609 Introduction Maintenance & AdjustmentsService Safe Servicing PracticesElectrical system Torque valuesTires LubricationFuel system Hydraulic systemOverservicing Recommended service procedureEngine oil and filter Engine air filterMower blade maintenance General engine maintenance BeltsStandard seat Seat adjustmentControl lever adjustment Mower blade removal6022230609 Hustler Z4 48/54/60 Maintenance Schedule Refer to Fig Hustler Z4 48/54/60 Maintenance Locator Chart Maintenance Locator Chart6022230609 Symptoms Probable Causes Suggested Remedies Hustler Z4 TroubleshootingPreparation of engine for storage Preparation of battery for storageStorage Product LiteratureIndex 6022230609

Z4 specifications

The Hustler Turf Z4 is an exceptional zero-turn mower designed for both commercial landscapers and residential users seeking high performance and efficiency. Known for its robust construction and outstanding maneuverability, the Z4 stands out in the competitive field of lawn care equipment.

One of the key features of the Hustler Turf Z4 is its powerful engine options. Equipped with a choice of Kawasaki or Kohler engines, the Z4 delivers reliable performance and impressive torque, ensuring that it can handle tough mowing conditions with ease. The engine options range from 19.5 to 25 horsepower, providing ample power for various lawn sizes and terrain types.

The Z4 features a cutting width of 42 to 54 inches, allowing users to cover large areas in less time. Its innovative cutting deck design promotes superior grass clipping dispersion, leaving behind a clean and even finish. The deck is reinforced for added durability, making it capable of withstanding the rigors of frequent use, whether in commercial landscapes or home lawns.

One of the standout technologies in the Hustler Turf Z4 is the patented SmoothTrak steering system, which allows for precise control and effortless turns. This feature enhances maneuverability around obstacles, flower beds, and tight corners, making mowing a more efficient task. Combined with its low center of gravity, the Z4 offers stability on hills and uneven surfaces.

The Hustler Turf Z4 also prioritizes user comfort and ease of operation. The ergonomic seat design supports long hours of mowing without discomfort, and the intuitive control layout ensures that even novice users can operate the mower with confidence. The easy-to-adjust cutting height allows for quick transitions between different grass types or blooming flowers.

Additionally, the Z4 is equipped with convenient maintenance features. The flip-up deck allows for easy access to the blades for cleaning and sharpening, while the integrated grease fittings simplify lubrication.

In conclusion, the Hustler Turf Z4 is a powerful and versatile zero-turn mower that combines advanced technology with user-friendly features. Designed for performance and durability, it caters to the needs of both professionals and homeowners who demand efficiency and quality in their lawn care equipment. Whether tackling expansive lawns or intricate landscaping, the Z4 rises to the occasion with style and precision.
Top Page Image Contents