Husqvarna K3600 MKII manual Settings and Adjustments, Drive, Fitting the blade, Basic service

SETTINGS AND ADJUSTMENTS

Drive

On account of the machine’s unique design the driving power is not transferred at the centre of the blade.The flanges on the two guide rollers run in the blade’s grooves. Springs on the guide rollers press out the rollers, which in turn press the V- shaped edge on the inside diameter of the blade against the V-shaped groove in the drive wheel. The drive wheel is fitted on an axle which is driven by the hydraulic motor.

This allows a total cutting depth of 260 mm (10 inches) with a 350 mm (14 inches) diamond blade.

1Blade

2Support rollers

3Drive wheel

4Guide rollers

5V-shaped edge

Basic service

As the blade is used the inside diameter and the groove in the drive wheel become worn.

The ring cutter will also work well in the future if:

•the drive wheel is not too worn

A)New

B)Worn

•the guide rollers are not too worn

A)New

B)Worn

•adjustment between the rollers and blade is correct.

The roller setting should be checked twice during the life of the diamond blade, once after fitting the blade and when the blade is semi worn.

Fitting the blade

WARNING! Always disconnect the power

!cutter from the hydraulic connection when performing a service. Unexpected blade movements can cause serious injuries.

We offers a number of blades for different materials in its range. Check with your Husqvarna dealer to see which blades are best suited for your usage.

WARNING! It is forbidden to reconstruct a

!used blade. A used blade may be weakened. A reconstructed blade can crack or break into pieces and seriously injury the operator or other persons.

WARNING! Check that the blade is not

!damaged before fitting it on the machine. Damaged blades can disintegrate and cause serious personal injury.

•Wipe off any dirt from the surface of the blade.

•Loosen the locking nuts on the support roller cover.

•Unscrew the adjuster screws a few turns.

English – 11