Settings and Adjustments

•Loosen the knob to ofﬂoad the springs.

•Pull out the lock for the front handle and move the handle to the service position.

•Remove the three screws holding the support roller guard using a 6 mm hex key and lift off the cover.

•Fit the blade.

CAUTION! The blade has a groove (A) on one side that acts a the guide groove for the support rollers. Ensure that the V-shaped edge of the blade enters the drive wheel and that the blade’s guide groove ﬁts in the guide rollers. Also see under the heading Drive.

•Press in the guide roller if necessary, so that it climbs into the groove on the blade.

•Fit the support roller guard and ensure that the ﬂanges on the guide rollers still enter the blade’s grooves correctly. Now tighten the three screws fully.

•Rotate the blade and make sure that the support rollers are not clamped against the blade.

•Adjust the adjuster screws so that the support rollers make contact against the blade.

•Adjust so you can easily stop the support rollers using your thumb when the blade is rotated. The support rollers should only follow the blade occasionally.

•Tighten the locking nuts on the support roller guard.

•Rotate the blade and make sure you can still hold the rollers with your thumb when the blade is rotated.

12 – English