Husqvarna 235F manual Assembling the cutting equipment, Fitting the blade guard and saw blade

Page 14

ASSEMBLY

Assembling the cutting equipment

WARNING! When fitting the cutting

!attachment it is extremely important that the raised section on the drive disc/ support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting a blade guard, grass blade and grass cutter

GF

E

D

A B

C

A

•Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt.

CAUTION! Ensure that the guard extension is removed.

Use the recommended blade guard. See the Technical data section.

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Place the blade (D), support cup (E) and support flange (F) on the output shaft.

•Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

Fitting the blade guard and saw blade

•Remove the mounting plate (H). Fit the adapter (I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown.

K

J

H

LI

A

14 – English

Page 13 Page 15
Image 14
Page 13 Page 15
Contents 235R 235FR Operator of the machine must Ensure, while working, that no KEY to SymbolsSymbols Persons or animals come closer thanContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard Quick releaseMuffler Locking nutGeneral rules Cutting equipmentCutting equipment Sharpening grass cutters and grass blades Sharpening the saw bladeTrimmer head Transport position, handlebar AssemblyFitting the handlebar Fitting the blade guard and saw blade Assembling the cutting equipmentFitting a blade guard, grass blade and grass cutter Fitting the trimmer guard and trimmer head Trimmy SII AM LSpreading the load on your shoulders Adjusting the harness and brush cutterFitting other guards and cutting attachments Forestry clearing Correct heightCorrect balance Grass clearingFuel Fuel safetyFuel Handling Fuelling MixingStarting and stopping Starting and StoppingCheck before starting Cold engineFor throttle handles with a start throttle lock Warm engineStarting StoppingGeneral working instructions Basic safety rulesWorking Techniques ABC of clearingControl the felling direction take advantage of the wind Forestry clearing using a saw blade Grass trimming with a trimmer head Grass clearing using a grass bladeBrush cutting with a saw blade TrimmingCutting SweepingMaintenance CarburettorBevel gear MufflerCooling system Spark plug Cleaning the air filterAir filter Oiling the air filterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataEC-declaration of conformity Applies to Europe only Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page Page Page Page Original instructions 1153284-26
Top Page Image Contents