Husqvarna 235F Fitting other guards and cutting attachments, Spreading the load on your shoulders

Page 16

ASSEMBLY

Fitting other guards and cutting attachments

•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. CAUTION! Ensure that the guard extension is fitted.

Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.

H

L

M

BA

C

AM L

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

H

H

•To dismantle, follow the instructions in the reverse order.

Adjusting the harness and brush cutter

WARNING! When using a brush cutter it

! must always be hooked securely to the harness. Otherwise you will be unable to control the brush cutter safely and this can result in injury to yourself or others. Never use a harness with a defective quick release.

Quick release

At the front is an easily accessible, quick release. Use this if the engine catches fire or in any other emergency situation that requires you to free yourself from the machine and harness.

Spreading the load on your shoulders

A well-adjusted harness and machine makes work much easier. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders.

16 – English

Page 15 Page 17
Image 16
Page 15 Page 17
Contents 235R 235FR KEY to Symbols SymbolsOperator of the machine must Ensure, while working, that no Persons or animals come closer thanContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system Quick releaseMuffler Locking nutCutting equipment Cutting equipmentGeneral rules Sharpening grass cutters and grass blades Sharpening the saw bladeTrimmer head Fitting the handlebar Assembly Transport position, handlebar Fitting a blade guard, grass blade and grass cutter Assembling the cutting equipmentFitting the blade guard and saw blade Fitting the trimmer guard and trimmer head Trimmy SII AM LFitting other guards and cutting attachments Adjusting the harness and brush cutterSpreading the load on your shoulders Correct height Correct balanceForestry clearing Grass clearingFuel Handling Fuel safetyFuel Fuelling MixingStarting and Stopping Check before startingStarting and stopping Cold engineWarm engine StartingFor throttle handles with a start throttle lock StoppingBasic safety rules Working TechniquesGeneral working instructions ABC of clearingControl the felling direction take advantage of the wind Forestry clearing using a saw blade Grass clearing using a grass blade Brush cutting with a saw bladeGrass trimming with a trimmer head TrimmingCutting SweepingMaintenance CarburettorCooling system MufflerBevel gear Cleaning the air filter Air filterSpark plug Oiling the air filterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataEC-declaration of conformity Applies to Europe only Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Auto Trimmy SII Page Page Page Page Original instructions 1153284-26
Top Page Image Contents