CARTON CONTENTS
Check carton contents against the fol-
lowinglist,
Model 358.792400
Edger Attachment
Handlebar (with Clamp and Knob)
Clamp Base (with Spacer Tabs)
Clamp Screws (4)
Attachment Hanger
Hex Wrench
Examine parts for damage. Do not use damaged parts.
NOTE: If you need assistance or find
parts missing or damaged, call
ASSEMBLY
_WARNING: | If received as- |
sembled, repeat all steps to ensure
your unit is properly assembled and all fasteners are secure.
• A hex wrench (provided) is required for assembly.
HANDLEBAR ASSEMBLY
DANGER: RISK OF CUT, To
avoid serious injury, the barrier portion of the handlebar must be installed as
shown on the upper tube of the pow- erhead to provide a barrier between operator and the spinning blade, At- tach tube clamp above arrow on safe- ty warning decal on the upper tube (powerhead end of unit). Ensure han- dlebar is positioned on handlebar
clamp between the arrows on the han- dlebar decal.
NOTE: The tube clamp base has four spacer tabs attached, These tabs are provided to adapt this attachment for use with powerheads that have a 1" diameter upper tube (the tube clamp will not tighten down securely on the 1" diameter upper tube without using these spacer tabs). The tabs must be broken off completely before use and placed over the screw holes on the clamp base. These tabs are not need-
ed for powerheads with a 7/8" upper tube.
HANDLEBAR CLAMP BASE
Spacer | Tabs | _ |
|
posi!ioned for | use_ _ | _ | |
on 1 | diameter | ||
upper | tube | _U |
|
1.Place the tube clamp over the up- per tube above the arrow on the safety decal.
2.Position the clamp base under the upper tube and align the tube clamp and clamp base screw holes (use spacer tabs between tube clamp and clamp base if necessary to secure clamp, i.e. for 1" diameter upper tube).
Handlebar
POWERHEAD
END
Handlebar Clamp between arrows on handlebar decal
Clam
Knob
SCOWS
Arrow on
Safety Decal
ATTACHMENT
END
3.Insert the four screws into the screw holes.
4.Secure tube clamp by tightening screws with the hex wrench,
5.Position the handlebar as shown, ensuring the handlebar is posi- tioned on the handlebar clamp be- tween the arrows on the handlebar decal,
6.Retighten handlebar by turning clamp knob clockwise until handle- bar is secure and stationary in clamp (clamp knob cannot be over- tightened).
6