INSTALLING ATTACHMENT
1.Remove the tube cap from the at- tachment (if present) and discard.
2.Position locking/release button of attachment into guide recess of up- per tube coupler.
Coupler Primary Hole
uide Recess
Upper Locking/ Attachment
Tube Release
Button
3.Push the attachment into the cou- pler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the
knob securely by turning clockwise.
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for storage when attachment is not in use.
To install hanger on attachment:
1.Remove the tube cap from the at- tachment (if present) and discard.
2.Press and hold the locking/release button.
3.Push hanger onto the attachment until the Iocking/releese button snaps into the hole.
OPERATING POSITION
ALWAYS WEAR:
Eye Protection
Long Pan£
Heavy Shoes
When operating unit, stand as shown and check for the following:
•Wear eye protection and heavy clothing.
•Keep right arm slightly bent with right hand holding the trigger handle ofpowerhead.
•Keep left arm extended with left hand holding the handlebar.
•Keep unit below waist level.
•Adjust edger wheel for proper cut depth.
_k WARNING: Never attempt to adjust the edger wheel when the unit is in operation. Always stop the pow- erhead, wait until the blade stops turn- ing, and disconnect the spark plug (or disconnect powerhead from power source) before making adjustments.
EDGING
As you become familiar with use of your edger attachment, you will be able to determine your own operating pace. Conditions such as depth of cut and material being cut will regulate the speed and time required for your edg- ing job.
•Allow the engine to warm up before you begin edging.
•Increase the engine speed before placing the blade in the cut. For best results, run the engine at full throttle while cutting.
•Always work going away from people and solid objects such as walls, large stones, trees, automobiles, etc.
•Be careful when edging near trees or valuable plants. The high speed met- al blade may cut roots and cause damage to the plants.
•If the blade stalls, immediately move
the unit back slightly to allow the blade to restart. If the blade continues
to stall, stop the engine, disconnect the spark plug, and inspect for block- age or damage.
_ WARNING: Keep the blade area
clean. Always release the throttle trig_ ger, move the powerhead ON/OFF switch to the OFF position, disconnect the spark plug (or disconnect power- head from power source), and make sure the blade has completely stopped turning before cleaning.
SETTING THE EDGING DEPTH
_WARNING: Never attempt to
adjust the cut depth when the engine is running. Always release the throttle trigger, wait until the blade stops turn-
ing, move the powerhead ON/OFF switch to the OFF position, and discom nect spark plug (or disconnect from power source) before making adjust- ments.
8