Monessen Hearth BBV400 Electrical Installation, Electrical Wiring, Remote Wall Mounted Switch

ELECTRICAL INSTALLATION BBV, SBV Series Natural Vent Gas Fireplaces

ELECTRICAL WIRING

WARNING

Electrical connections should only be performed by a qualified, licensed electrician. Main power must be off when connecting to main electrical power supply or performing service. All wiring shall be in compliance with all local, city and state codes. The appliance, when installed, just be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code ANSI/NFPA 70 (latest edi- tion) and Canadian Electrical Code, CSA C22.1.

CAUTION

Label all wires before disconnecting when servicing controls. Wiring errors can cause improper and dangerous op- eration.

Verify proper operation after servicing.

REMOTE WALL MOUNTED SWITCH

A remote wall switch and up to fifteen (15) feet of 18 Ga. wire may be used with this appliance. Attach the wall switch in a junction box at the desired location on the wall. Figure 16. Do not extend beyond the wall switch wire length provided.

NOTE: Extended lengths of wire may cause the fireplace not to function properly. Longer length of wire is permitted if the wire is made out of larger gauge (diameter) wire. Always check with local codes.

PILOT	HI
OFF	ON
	TH
	TP
	TH/TP

Figure 16 -

Wall Switch Wiring Diagram

		OPTIONAL REMOTE
		WALL SWITCH
	SPILL	ON
	SWITCH
ON	RS	OFF
	OFF
		OPTIONAL REMOTE
		WALL SWITCH
		ON
		OFF

WARNING

Do not connect wall switch to AC (110 V) circuit.

62D4036 17