Monessen Hearth SBV400 Lighting Pilot, Operating Instructions, Approved Leak Testing Method, body

OPERATING INSTRUCTIONS BBV, SBV Series Natural Vent Gas Fireplaces

LIGHTING PILOT FOR THE FIRST TIME

APPROVED LEAK TESTING METHOD

You may check for gas leaks with the following methods only:

•Soap and water solution

•An approved leak testing spray

•Electronic sniffer

DANGER	Never check for gas leaks with open
	flame!

WARNING	If using a soap and water solu-
	tion to test for leaks, DO NOT
	spray solution onto control
	body.

NOTE: Remove any excessive pipe compound from the connec- tions. Excessive pipe compound can set off electronic sniffers.

Check for gas leaks in each of the following locations: Pipe from the gas supply line connection to the gas valve

•	Burner connections	• Field made joints / gas shut-off valve
•	Pilot	•	Factory made joints
• Each joint or connection		•	All joints on valve and control body

WARNING

LIGHTING PILOT

The control has an interlock device that does not allow the lighting of the fireplace up to the moment the safety device of the flame has not interrupted the gas flow. After that pe- riod of time (when the magnet is closed), it is possible to start the lighting operation.

The gas control knob is designed to be operated by hand. DO NOT use any tools during this operation. Damaged knobs may result in serious injury.

1.Depress and turn knob counterclockwise to pilot position.

2.Depress fully and hold pilot gas knob. The electronic ig- nitor will automatically ignite the pilot. Keep knob fully depressed for a few seconds. Release and check that pilot continues to burn.

If the pilot does not stay lit, repeat Steps 1 and 2.

	O
T		N
O
L
I
P
	F
	F
PI		O
	L
		O
			T

Figure 20 -

Pilot Position

62D4036 21