OPERATING
E
D
C
MX7674x
7.Loosen leveling nut (D), one on each side, and make sure bolts and leveling brackets slide freely in slots.
8.Raise lift handle to highest position and then lower back down to 25 mm (1 in.) cutting height to position the deck and brackets.
9.Apply slight pressure on leveling brackets (E), one on each side, by pulling down to remove slack in linkage. Tighten nuts (D), one on each side, to 55 N•m (40
10.Turn adjusting nut (C) on front draft arm clockwise until deck begins to raise off wood blocks.
11.Set preferred cutting height.
12.Check
C
MX10529
•Turn front adjusting nut (C) clockwise to raise front of mower deck or counterclockwise to lower front of mower deck.
Testing Safety Systems
cCAUTION: Avoid injury! Engine exhaust fumes
contain carbon monoxide and can cause serious illness or death.
Move the vehicle to an outside area before running the engine.
Do not run an engine in an enclosed area without adequate ventilation.
•Connect a pipe extension to the engine exhaust pipe to direct the exhaust fumes out of the area.
•Allow fresh outside air into the work area to clear the exhaust fumes out.
Use the following checkout procedure to check for normal operation of machine.
If there is a malfunction during one of these procedures, Do not operate machine. See your Sabo dealer for service.
Perform these tests in a clear open area. Keep bystanders away.
Testing Park Brake Switch
1.Park machine safely. (See Parking Safely in the SAFETY Section.)
2.Sit on seat.
Operating - 14