ASSEMBLY
Charge and Connect Battery
cCAUTION: Avoid injury! The battery produces a flammable and explosive gas. The battery may explode:
•Do not smoke near battery.
•Wear eye protection and gloves.
•Do not allow direct metal contact across battery posts.
•Remove negative cable first when disconnecting.
•Install negative cable last when connecting.
1.Remove and discard the red positive (+) protective cap from the positive (+) battery terminal.
2.Charge the battery.
•Battery is fully charged at 12.6 volts.
B
A
MX7686
3.Connect positive (+) battery cable (A) to battery.
4.Connect negative
5.Apply general purpose grease or silicone spray to terminal to help prevent corrosion.
6.Slide red cover over positive battery cable.
Check Tire Pressure
cCAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly:
•Do not attempt to mount a tire without the proper equipment and experience to perform the job.
•Do not inflate the tires above the recommended pressure.
•Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel.
•Do not stand in front or over the tire assembly when inflating. Use a
1.Check tires for damage.
2.Check tire pressure with an accurate gauge.
3.Check that tires have equal air pressure. Add or remove air, if necessary.
Tire Size | Pressure |
|
|
|
|
Front: 15 x 6.00 - 6 | 0,97 bar (97 kPa) (14 psi) |
|
|
Rear: 20 x 8.0 - 8 | 0,69 bar (69 kPa) (10 psi) |
|
|
Adjust Mower Level
Adjust mower level. (See Adjusting Mower Level in the OPERATING section.)
Check Machine Safety System
Perform safety system check to make sure the electronic safety interlock circuit is functioning properly. Perform all tests. (See Testing Safety System in the Operating section.)
Assembly - 51