Polycom CCUG-0100-01 manual Options

Page 11

DEVICE PARAMETERS

be difficult to light. If you set the signal activity level too low, the ambient room noise may light the signal activity LED too easily.

Figure 7. Signal Activity LED of Inputs and Outputs.

The ability to follow signal flow and the Signal Activity LED can provide useful tools to ensure that the proper input to output mappings have been setup.

OPTIONS

Figure 8. Options Tab.

The OPTIONS tab allows the user to set the following parameters:

•MODEM INITIALIZATION STRING. The modem initialization string, if enabled,

© Polycom, Inc.

9

Conference Composer User Guide

Image 11

Contents Conference Composer User Guide Page Conference ComposerTM Software Introduction InstallationUsing Conference Composer with a Vortex and EF200 Phone ADD Conference Composertm SoftwareFeatures of the Conference Composer Window Conference Composertm Software Operating Conference Composer OFF-LINE Operating Without AN EF Device Project gen- erated when connected to a VortexOperating Conference Com- poser Offline System Device ParametersOptions Device Name MIC/LINE Inputs Input Filters Automixer EF BUS Exporting the Echo Canceller Reference onMatrix Mixer Device Parameters Outputs Output FiltersLogic Input Logic Output Macros PresetsDiagnostics Creating Reports Project Files and Creating ReportsFile Saving File RestoringConsole TAB Console WindowProperties TAB Updating Firmware Update Your EF DeviceConsole Window Conference Composer On Site with the Vortex Modem USE with the VortexSite From the RemoteVerify That Vortex is Sending Correct Init String Troubleshooting the Vortex Modem Connection