Porter-Cable BSV750 instruction manual Storage, Engine Preparation, Generator, Battery

Page 17

STORAGE

If you are going to store your generator for more than 30 days, use the following information as a guide to prepare the generator for storage.

Never store generator with fuel in the tank indoors or in enclosed, poorly ventilated areas, where fumes can reach

an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or other gas appliances.

ENGINE PREPARATION

1.Add fuel stabilizer to fuel tank to minimize the formation of fuel gum deposits during storage.

2.Run engine at least 10 minutes after adding stabilizer to allow it to enter the fuel system.

3.Next shut off engine.

4.Disconnect the spark plug wire and remove the spark plug.

5.Add one teaspoon of oil through the spark plug hole.

6.Place rag over spark plug hole and pull the recoil a few times to lubricate the combustion chamber.

7.Replace the spark plug, but do not connect the spark plug wire.

NOTE: If a fuel stabilizer is not used, all gasoline must be drained from the tank and carburetor to prevent gum deposits from forming on these parts and causing possible malfunction of the engine.

GENERATOR

Clean the generator as outlined in the Maintenance Section on this manual.

Check that cooling air slots and openings on generator are open and unobstructed.

BATTERY

Store battery as described by the battery manufacturer.

NOTE: After storing battery for a long period of time it may lose its charge. If the battery loses its charge, manually start the engine with the battery connect- ed. The engine will recharge the battery as it runs.

17- ENG

D29525

Image 17
Contents Generator Read and understand all safety warnings Consumer General and Service InformationConsumer Safety Information Risk of Electrocution and Fire Safety Guidelines / DefinitionsImportant Safety Instructions Risk of Electrocution and Fire When damagedOperation Generator in rainConfined Area Risk of FireUnit Indoors or in ANY Risk of Unsafe Operation Risk of Breathing Inhalation HazardRisk of HOT Surfaces BSV750 SpecificationsRisk of Moving Parts Risk from LiftingRemove Generator from Carton AssemblyOther Loose Parts Grounding the GeneratorTo Prevent sparks connect the red Typical Installation of BatteryExtension Cord Wire Gauge Chart Double Throw Transfer SwitchObtaining Electricity from the Generator Extension CordsOperation Gas 12V DC OutletBefore Start UP Odorless and deadly gas To Start the EngineStopping Engine Connecting Electrical LoadsMaintenance Storage BatteryEngine Preparation GeneratorRunning Watts Starting Watts Wattage CalculationsDetermining Wattage Requirements Volts X Amp = Watts Example 120 volts x 10 amps = 1200 watts Starting Wattage RequirementsTypical Device Wattage Total Household Wattage CalculatorProblem Responsibility of Original Purchaser initial User Limited WarrantyENG Quick Facts