Poulan 960420022, 404402 manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 25

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANTTO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTUREWHICH LEADSTO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVERTRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Always Wear EYE Protection During Operation PB24H48YTSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Unassembled Parts AssemblyTo Remove Tractor from Carton Unpack CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Reverse Operation System ROS on Position Know Your TractorStopping HOW to USE Your TractorTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigSystem Characteristics To Operate MowerBefore Starting the Engine Service REMINDER/HOUR MeterTo Operate on Hills Check Engine OIL LevelPurge Transmission To Start Engine See FigAutomatic Transmission Warm UP Mowing Tips Before Each USE MaintenanceTractor BatteryBrake Operation TiresEngine Muffler CleaningSpark Plugs IN-LINE Fuel Filter See FigTo Install Mower See Figs Service and AdjustmentsTractor See Fig To Remove MowerFirst Install ANTI-SWAY BAR S To Level Mower Tip of the blade To Replace Motion Drive Belt See Fig To Replace Mower Blade Drive Belt See FigTo Check Brake To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILTroubleshooting Points Engine dies when Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

960420022, 404402 specifications

The Poulan 960420022,404402 is a well-regarded chainsaw recognized for its blend of performance, durability, and user-friendly features. Manufactured by Poulan, a brand known for its commitment to delivering high-quality outdoor power equipment, this model is designed to meet the needs of both professional landscapers and home users alike.

At the heart of the Poulan 960420022,404402 is its powerful engine. Equipped with a robust two-stroke engine, this chainsaw can produce ample power for cutting through tough wood and tackling various outdoor tasks. The engine is designed with fuel efficiency in mind, allowing users to operate for extended periods without frequent refueling. Its quick-start technology ensures that users can get to work without the frustration of lengthy startup times.

One of the standout features of the Poulan 960420022,404402 is its low-vibration design. This technology not only enhances user comfort during operation but also reduces fatigue, making it ideal for prolonged use. The handle is ergonomically designed to provide a secure grip, ensuring maximum control while cutting.

Another notable characteristic is the chainsaw’s automatic oiler system. This feature provides continuous lubrication to the chain and bar, minimizing wear and ensuring smooth operation. Regular maintenance is simplified, as the tool-free chain tensioning system allows users to easily adjust the chain without the need for additional tools.

Safety is a primary concern for any power tool, and the Poulan 960420022,404402 incorporates several safety features. It includes a chain brake, which acts quickly in the event of kickback, providing an extra layer of protection for users. A transparent fuel tank allows for easy monitoring of fuel levels, further enhancing safety and preventing operational interruptions.

The Poulan 960420022,404402 is compatible with various bar lengths, allowing users to customize their chainsaw for different tasks, from tree trimming to firewood preparation. This adaptiveness makes it a versatile choice for anyone looking to invest in a reliable chainsaw.

In summary, the Poulan 960420022,404402 stands out with its powerful engine, low-vibration design, automatic oiler system, easy chain adjustment, and essential safety features. Whether tackling large projects or performing routine yard maintenance, this chainsaw offers the performance and reliability users expect from a trusted brand.
Top Page Image Contents