Poulan 960420022, 404402 manual Engine dies when

Page 27

TROUBLESHOOTING POINTS

PROBLEM

CAUSE

CORRECTION

 

 

 

 

 

Engine dies when

1.

Reverse operation system

1.

Turn ignition key to

tractor is shifted

 

(ROS) is not "ON" while

 

ROS "ON" position.

into reverse

 

mower or other attachment

 

See Operation section.

 

 

is engaged.

 

 

 

 

 

 

 

Engine continues to run

1.

Faulty operator-safety presence control system.

1.

Check wiring, switches and connections. If not

when operator leaves seat

 

 

 

corrected, contact an authorized service center/

with attachment clutch

 

 

 

department.

engaged

 

 

 

 

 

 

 

 

 

Poor cut - uneven

1.

Worn, bent or loose blade.

1.

Replace blade. Tighten blade bolt.

 

2.

Mower deck not level.

2.

Level mower deck.

 

3.

Buildup of grass, leaves, and trash under mower.

3.

Clean underside of mower housing.

 

4.

Bent blade mandrel.

4.

Replace blade mandrel.

 

5.

Clogged mower deck vent holes from buildup of

5.

Clean around mandrels to open vent holes.

 

 

grass, leaves, and trash around mandrels.

 

 

 

 

 

 

 

Mower blades will not

1.

Obstruction in clutch mechanism.

1.

Remove obstruction.

rotate

2.

Worn/damaged mower drive belt.

2.

Replace mower drive belt.

 

3.

Frozen idler pulley.

3.

Replace idler pulley.

 

4.

Frozen blade mandrel.

4.

Replace blade mandrel.

 

 

 

 

 

Poor grass discharge

1.

Engine speed too slow.

1.

Place throttle control in “FAST” position.

 

2.

Travel speed too fast.

2.

Shift to slower speed.

 

3.

Wet grass.

3.

Allow grass to dry before mowing.

 

4.

Mower deck not level.

4.

Level mower deck.

 

5.

Low/uneven tire air pressure.

5.

Check tires for proper air pressure.

 

6.

Worn, bent or loose blade.

6.

Replace blade. Tighten blade bolt.

 

7.

Buildup of grass, leaves and trash under mower.

7.

Clean underside of mower housing.

 

8.

Mower drive belt worn.

8.

Replace mower drive belt.

 

9.

Blades improperly installed.

9.

Reinstall blades sharp edge down.

 

10.

Improper blades used.

10.

Replace with blades listed in this manual.

 

11.

Clogged mower deck vent holes from buildup of

11.

Clean around mandrels to open vent holes.

 

 

grass, leaves, and trash around mandrels.

 

 

 

 

 

 

 

Headlight(s) not working

1.

Light switch is “OFF”.

1.

Turn light switch “ON”.

(if so equipped)

2.

Bulb(s) or lamp(s) burned out.

2.

Replace bulb(s) or lamp(s).

 

3.

Faulty light switch.

3.

Check/replace light switch.

 

4.

Loose or damaged wiring.

4.

Check wiring and connections.

 

5.

Blown fuse.

5.

Replace fuse.

 

 

 

 

 

Battery will not charge

1.

Bad battery cell(s).

1.

Replace battery.

 

2.

Poor cable connections.

2.

Check/clean all connections.

 

3.

Faulty regulator (if so equipped).

3.

Replace regulator.

 

4.

Faulty alternator.

4.

Replace alternator.

 

 

 

 

 

Loss of drive

1.

Freewheel control in “disengaged” position.

1.

Place freewheel control in “engaged” position.

 

2.

Motion drive belt worn, damaged, or broken.

2.

Replace motion drive belt.

 

3.

Air trapped in transmission during shipment

3.

Purge transmission.

 

 

or servicing.

 

 

 

 

 

 

 

Engine “backfires” when

1.

Engine throttle control not set between half and

1.

Move throttle control between half and full speed

turning engine “OFF”

 

full speed (fast) position before stopping engine.

 

(fast) position before stopping engine.

 

 

 

 

 

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Always Wear EYE Protection During Operation PB24H48YTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationService III. ChildrenIV. Towing Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Reverse Operation System ROS on Position Know Your TractorStopping HOW to USE Your TractorTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine To Operate on HillsTo Start Engine See Fig Purge TransmissionAutomatic Transmission Warm UP Mowing Tips Before Each USE MaintenanceTires BatteryTractor Brake OperationEngine IN-LINE Fuel Filter See Fig CleaningMuffler Spark PlugsTo Remove Mower Service and AdjustmentsTo Install Mower See Figs Tractor See FigFirst Install ANTI-SWAY BAR S To Level Mower Tip of the blade To Replace Motion Drive Belt See Fig To Replace Mower Blade Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Engine dies when Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

960420022, 404402 specifications

The Poulan 960420022,404402 is a well-regarded chainsaw recognized for its blend of performance, durability, and user-friendly features. Manufactured by Poulan, a brand known for its commitment to delivering high-quality outdoor power equipment, this model is designed to meet the needs of both professional landscapers and home users alike.

At the heart of the Poulan 960420022,404402 is its powerful engine. Equipped with a robust two-stroke engine, this chainsaw can produce ample power for cutting through tough wood and tackling various outdoor tasks. The engine is designed with fuel efficiency in mind, allowing users to operate for extended periods without frequent refueling. Its quick-start technology ensures that users can get to work without the frustration of lengthy startup times.

One of the standout features of the Poulan 960420022,404402 is its low-vibration design. This technology not only enhances user comfort during operation but also reduces fatigue, making it ideal for prolonged use. The handle is ergonomically designed to provide a secure grip, ensuring maximum control while cutting.

Another notable characteristic is the chainsaw’s automatic oiler system. This feature provides continuous lubrication to the chain and bar, minimizing wear and ensuring smooth operation. Regular maintenance is simplified, as the tool-free chain tensioning system allows users to easily adjust the chain without the need for additional tools.

Safety is a primary concern for any power tool, and the Poulan 960420022,404402 incorporates several safety features. It includes a chain brake, which acts quickly in the event of kickback, providing an extra layer of protection for users. A transparent fuel tank allows for easy monitoring of fuel levels, further enhancing safety and preventing operational interruptions.

The Poulan 960420022,404402 is compatible with various bar lengths, allowing users to customize their chainsaw for different tasks, from tree trimming to firewood preparation. This adaptiveness makes it a versatile choice for anyone looking to invest in a reliable chainsaw.

In summary, the Poulan 960420022,404402 stands out with its powerful engine, low-vibration design, automatic oiler system, easy chain adjustment, and essential safety features. Whether tackling large projects or performing routine yard maintenance, this chainsaw offers the performance and reliability users expect from a trusted brand.
Top Page Image Contents