Poulan 411259 manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PB22H46YT ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Ignition Switch Used for starting and stopping the engine Know Your TractorHOW to USE Your Tractor To Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerService REMINDER/HOUR Meter Before Starting the EngineReverse Operation System ROS To Operate on HillsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check and Adjust Brake See Fig To Adjust BrakeTo Replace Mower Drive Belt To Check BrakeTo Start Engine with a Weak Battery See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty L5V 3E4Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Suivant LES UNE Pliez EST CeciRemarque Autorisé Garantie cette de exclus sont normal l’entretien etInitiale d’achat date la de compter à jours 90 dix Dépannage DE Guide Connexions les et interrupteurs les câblage, le VérifiezLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage GAZ DES Commande Reglages ET RevisionCarburateur LE Régler Pour Fig la Voir Batterie LA ReplacerFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour Avant Roue LA DE PINCEMENT/CARROSSAGEFig la Voir D’ENTRAÎNEMENT Courroie LA Remplacer Pour 29 .FIGRéglages ET Révision Fig la VoirFrein LE Régler ET Contrôler Pour ’EN Courroie LA Remplacer PourTondeuse LA Niveau LE Ajuster Pour 25 .FIG24 .FIG 23 .FIG21 .FIG 19 .FIG 20 .FIG18 .FIG Place en bien est courroie la que vous-Assurez ImportantCourroie LA ET Tondeuse LA Installer Figs Voir D’ENTRAÎNEMENTFig Voir Tondeuse LA Enlever PourLigne EN Installe Dessence Filtre Entretien’ALLUMAGE Bougie Moteur DE D’HUILE FiltreMoteur Fig la Voir Lame LA Enlever EN Fonctionnement DE Système ETLubrification DE Tableau Utilisation Chaque AvantAvant ET Réinstallation LA Après Purgée Être UtilisationTransmission LA Purger 12 .FIGR R a M É D ’ESSENCE Réservoir LE RemplirMoteur DU D’HUILE Niveau LE Vérifier QuetimaautoAccessoires Autres ET Charrettes DES Remorquer Pour ’ENTRETIEN/HOROMÈTRE Indicateur11 et 3 .Fig les Voir Pentes LES Dans Utiliser PourVitess DE Régulateur LE Utiliser CommentTondeuse LA Utiliser Pour Jauge DE Roues LES Régler PourGAZ DES Commande LA Utiliser Pour Létrangleur Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour Fig la Voir Arrêter Pour 4 .FIGFroid moteur un démarrer de permet Détrangleur Commande N Moteur de vitesse la commander de permet GAZ DES Commande D’EMBRAYAGE Montage Desmancom des tionfonc la etTionsec la Voir Conduisant LE EN Telet PA LA DE Tracteur LE Retirer PourMontées NON Piéces Toncar DU Tracteur LE Sortir PourSommaire Général Entretien Tracteurs des sécurité touteEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils Pelouse DE Tracteur PB22H46YT Modèle Lopérateur DE Manuel

411259 specifications

The Poulan 411259 is a powerful and efficient chainsaw that caters to both casual users and professionals alike. Known for its reliability and performance, this model integrates advanced features and technology to ensure it meets the demands of various cutting tasks, whether it's for trimming branches, cutting firewood, or clearing fallen trees.

One of the standout features of the Poulan 411259 is its robust 42cc engine, which provides ample power for demanding jobs without compromising on ease of use. The engine is designed to deliver strong performance while maintaining fuel efficiency, making it an environmentally friendly choice for users who want to minimize their carbon footprint. Additionally, the chainsaw is equipped with a 16-inch bar and chain, allowing for a sufficient cutting capacity that is ideal for handling mid-sized logs and branches with ease.

Another key technology incorporated in the Poulan 411259 is its automatic oiling system. This feature ensures that the chain is consistently lubricated during operation, reducing friction and heat buildup, which ultimately prolongs the life of the chain and bar. This self-lubricating system contributes to smoother cuts and enhances the overall performance of the chainsaw.

User comfort is also a priority in the design of the Poulan 411259. The chainsaw is built with an ergonomic handle that allows for a secure grip, reducing fatigue during extended use. The lightweight construction of the chainsaw further enhances maneuverability, making it easier to navigate through branches and tight spaces. The accessible controls provide straightforward operation, ensuring that both seasoned users and novices can handle the tool effectively.

Safety features are paramount in the Poulan 411259, which includes a chain brake that halts the chain's movement in the event of kickback. The protective design elements help to ensure that users can operate the chainsaw with confidence, knowing that safety measures are in place.

In summary, the Poulan 411259 combines power, efficiency, and user-friendly features in a reliable chainsaw. With its durable engine, automatic lubrication, ergonomic design, and essential safety technologies, it stands out as an excellent tool for tackling a variety of cutting jobs in both residential and professional settings. Whether one is maintaining a garden or managing larger woodcutting tasks, the Poulan 411259 is a capable companion that delivers consistent results.
Top Page Image Contents