Poulan PBGTE, 406255 To USE Cruise Control -J See Fig, To Adjust Mower Cutting Height See Fig

Page 13

OPERATION

J

K

L

FIG. 17

TO USE CRUISE CONTROL -J (See Fig. 17)

The cruise control feature can be used for forward travel only.

SYSTEM CHARACTERISTICS

The cruise control should only be used while mowing or transporting on relatively smooth, straight surfaces. Other conditions such as trimming at slow speeds may cause the cruise control to disengage. Do not use the cruise control on slopes, rough terrian or while trimmimg or turning.

•With forward drive pedal depressed to desired speed, pull cruise control lever (J) up and hold while lifting your foot off the pedal, then release the lever.

To disengage the cruise control, depress the brake pedal or tap on forward drive pedal.

TO ADJUST MOWER CUTTING HEIGHT (See Fig. 18)

The position of the attachment lift lever (A) determines the cutting height.

•The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height.

TO ADJUST GAUGE WHEELS (See Fig. 19)

Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions.

NOTE: Adjust gauge wheels with tractor on a flat level surface.

•Adjust mower to desired cutting height (See “TO AD- JUST MOWER CUTTING HEIGHT” in this section of manual).

•With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole. Tighten securely.

•Repeat for all, installing gauge wheel in same adjust- ment hole.

A

FIG. 18

•Put attachment lift lever in desired cutting height slot.

•Slide pointer tab (T) to desired cutting height as a reminder for next time you mow.

The cutting height range is approximately 1" to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

FIG.19

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting off when operating your equipment on rough, rolling terrain or hills.

1.Select desired height of cut with attachment lift lever.

2.Start mower blades by engaging attachment clutch control.

TO STOP MOWER BLADES - disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped,or the deflector shield (S) in place.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Always Wear EYE Protection During Operation PbgtgeSafe Operation Practices for RIDE-ON Mowers Safety RulesGeneral Operation II. Slope OperationSafe Operation Practices for RIDE-ON Mowers III. Children ServiceIV. Towing Table of Contents Mower Mower Front Wheel Unassembled PartsSlope Sheet KeysTools Required for Assembly AssemblyTo Remove Tractor from Carton First Install ANTI-SWAY BAR S Install Mower and Drive Belt See FigsAssemble Front Wheel to Mower See Fig7/16 Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Reverse Operation System ROS on Position Know Your TractorStopping HOW to USE Your TractorTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigSystem Characteristics To USE Cruise Control -J See FigUsing the Reverse Operation System Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on HillsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMowing Tips Before Each USE MaintenanceTractor BatteryBrake Operation TiresEngine Engine OIL Filter CleaningMuffler Spark PlugsTo Install Mower Service and AdjustmentsTo Remove Mower See Fig To Level MowerTurn nut right Turn nut left To raise mower To Check Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILTroubleshooting Points Engine dies when Page Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PBGTE, 406255 specifications

The Poulan 406255, PBGTE is a powerful and versatile tool designed for home and commercial use, particularly favored for its performance in landscaping and yard maintenance tasks. Known for its reliability, this gas-powered string trimmer combines efficiency with user-friendly features, making it an excellent choice for both novices and experienced users alike.

One of the standout features of the Poulan 406255, PBGTE is its robust 25 cc, 2-cycle gas engine. This powerful engine offers a perfect balance of performance and fuel efficiency, allowing users to tackle tough jobs without frequent refueling. The engine’s design also ensures smoother operation, providing consistent power to the cutting head for a cleaner cut and enhanced productivity.

The trimmer’s lightweight design, weighing in under 10 pounds, enhances maneuverability and reduces user fatigue during extended use. The adjustable handle provides an additional layer of comfort, allowing users to customize the grip for optimal control. This feature is particularly beneficial for extensive trimming sessions, where comfort is paramount to achieving professional results.

Equipped with a dual-line cutting head, the Poulan 406255, PBGTE delivers an impressive cutting width that allows users to cover more ground with fewer passes. The trimmer is designed for easy line replacement, which minimizes downtime. Users can quickly reload the cutting line, ensuring that they can get back to work without delays.

Another notable technology integrated into the Poulan 406255, PBGTE is the Easy Start system. This system simplifies the starting process, making it easier for users to start the engine with minimal effort. As a result, even those unfamiliar with gas-powered tools will appreciate the straightforward functionality of this trimmer.

For maximum safety, the tool includes features such as a protective debris shield, which helps protect the user from flying debris while trimming. The combination of safety aspects and robust performance makes the Poulan 406255, PBGTE a dependable choice for varied landscaping tasks.

In conclusion, the Poulan 406255, PBGTE stands out for its powerful engine, ergonomic design, dual-line cutting head, Easy Start technology, and safety features. This trimmer offers a blend of efficiency, comfort, and safety, making it an essential tool for anyone looking to maintain their outdoor space effectively. Whether you are trimming grass, weeds, or smaller brushes, this trimmer is built to handle the challenge with ease and reliability.
Top Page Image Contents