Poulan 406255, PBGTE manual Tools Required for Assembly, To Remove Tractor from Carton

Page 6

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping pur- poses.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)

3/4" wrench

(1)

Utility knife

(1)

9/16" wrench

(1)

Pliers

(1)

Tire Pressure Gauge

 

 

When right or left hand is mentioned in this manual, it means from your point of view, when you are in the operat- ing position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton .

•Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.

•Remove mower and packing materials.

•Check for any additional loose parts or cartons and remove.

A

FIG. 2

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

CHECK BATTERY (See Fig. 1)

•Lift hood to raised position.

NOTE: If this battery is put into service after month and year indicated on label (L) (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

L

02931

FIG. 1

ADJUST SEAT (See Fig. 2)

•Sit in seat.

•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

•Release lever to lock seat in position.

TO ROLL TRACTOR OFF SKID

(See operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Release parking brake by depressing brake pedal.

•Place freewheel control in disengaged position to dis- engage transmission (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

TO DRIVE TRACTOR OFF SKID

(See operation section for location and function of controls)

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).

•Sit on seat in operating position, depress brake pedal and set the parking brake.

•Raise attachment lift lever to its highest position.

•Remove key from bag and start the engine (see "TO START" in the Operation section of this manual). After engine has started, move throttle control to idle (slow) position.

•Release parking brake.

•Slowly depress forward drive pedal and drive tractor off skid.

•Apply brake to stop tractor and set parking brake.

•Turn ignition key to "STOP" position.

Continue with the instructions that follow.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Pbgtge Always Wear EYE Protection During OperationGeneral Operation Safety RulesSafe Operation Practices for RIDE-ON Mowers II. Slope OperationService Safe Operation Practices for RIDE-ON Mowers III. ChildrenIV. Towing Table of Contents Slope Sheet Unassembled PartsMower Mower Front Wheel KeysAssembly Tools Required for AssemblyTo Remove Tractor from Carton Assemble Front Wheel to Install Mower and Drive Belt See FigsFirst Install ANTI-SWAY BAR S Mower See Fig7/16 Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingSystem Characteristics To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control -J See FigReverse Operation System ROS Service REMINDER/HOUR MeterUsing the Reverse Operation System To Operate on HillsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Maintenance Before Each USEBrake Operation BatteryTractor TiresEngine Muffler CleaningEngine OIL Filter Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower To Level MowerTurn nut right Turn nut left To raise mower To Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt See Fig To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Engine dies when Page Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PBGTE, 406255 specifications

The Poulan 406255, PBGTE is a powerful and versatile tool designed for home and commercial use, particularly favored for its performance in landscaping and yard maintenance tasks. Known for its reliability, this gas-powered string trimmer combines efficiency with user-friendly features, making it an excellent choice for both novices and experienced users alike.

One of the standout features of the Poulan 406255, PBGTE is its robust 25 cc, 2-cycle gas engine. This powerful engine offers a perfect balance of performance and fuel efficiency, allowing users to tackle tough jobs without frequent refueling. The engine’s design also ensures smoother operation, providing consistent power to the cutting head for a cleaner cut and enhanced productivity.

The trimmer’s lightweight design, weighing in under 10 pounds, enhances maneuverability and reduces user fatigue during extended use. The adjustable handle provides an additional layer of comfort, allowing users to customize the grip for optimal control. This feature is particularly beneficial for extensive trimming sessions, where comfort is paramount to achieving professional results.

Equipped with a dual-line cutting head, the Poulan 406255, PBGTE delivers an impressive cutting width that allows users to cover more ground with fewer passes. The trimmer is designed for easy line replacement, which minimizes downtime. Users can quickly reload the cutting line, ensuring that they can get back to work without delays.

Another notable technology integrated into the Poulan 406255, PBGTE is the Easy Start system. This system simplifies the starting process, making it easier for users to start the engine with minimal effort. As a result, even those unfamiliar with gas-powered tools will appreciate the straightforward functionality of this trimmer.

For maximum safety, the tool includes features such as a protective debris shield, which helps protect the user from flying debris while trimming. The combination of safety aspects and robust performance makes the Poulan 406255, PBGTE a dependable choice for varied landscaping tasks.

In conclusion, the Poulan 406255, PBGTE stands out for its powerful engine, ergonomic design, dual-line cutting head, Easy Start technology, and safety features. This trimmer offers a blend of efficiency, comfort, and safety, making it an essential tool for anyone looking to maintain their outdoor space effectively. Whether you are trimming grass, weeds, or smaller brushes, this trimmer is built to handle the challenge with ease and reliability.
Top Page Image Contents