Poulan 406255, PBGTE manual Engine dies when

Page 28

TROUBLESHOOTING POINTS

PROBLEM

CAUSE

CORRECTION

Engine dies when

1.

Reverse operation system

1.

Turn ignition key to

tractor is shifted

 

(ROS) is not "ON" while

 

ROS "ON" position.

into reverse

 

mower or other attachment

 

See Operation section.

 

 

is engaged.

 

 

 

 

 

 

 

Engine continues to

1.

Faulty operator-safety presence control system.

1.

Check wiring, switches and connections. If not

run when operator

 

 

 

corrected, contact an authorized service center/

leaves seat with

 

 

 

department.

attachment clutch

 

 

 

 

engaged

 

 

 

 

 

 

 

 

 

Poor cut - uneven

1.

Worn, bent or loose blade.

1.

Replace blade. Tighten blade bolt.

 

2.

Mower deck not level.

2.

Level mower deck.

 

3.

Buildup of grass, leaves, and trash under mower.

3.

Clean underside of mower housing.

 

4.

Bent blade mandrel.

4.

Replace blade mandrel.

 

5.

Clogged mower deck vent holes from buildup of

5.

Clean around mandrels to open vent holes.

 

 

grass, leaves, and trash around mandrels.

 

 

 

 

 

 

 

Mower blades will not

1.

Obstruction in clutch mechanism.

1.

Remove obstruction.

rotate

2.

Worn/damaged mower drive belt.

2.

Replace mower drive belt.

 

3.

Frozen idler pulley.

3.

Replace idler pulley.

 

4.

Frozen blade mandrel.

4.

Replace blade mandrel.

 

 

 

 

 

Poor grass discharge

1.

Engine speed too slow.

1.

Place throttle control in “FAST” position.

 

2.

Travel speed too fast.

2.

Shift to slower speed.

 

3.

Wet grass.

3.

Allow grass to dry before mowing.

 

4.

Mower deck not level.

4.

Level mower deck.

 

5.

Low/uneven tire air pressure.

5.

Check tires for proper air pressure.

 

6.

Worn, bent or loose blade.

6.

Replace blade. Tighten blade bolt.

 

7.

Buildup of grass, leaves and trash under mower.

7.

Clean underside of mower housing.

 

8.

Mower drive belt worn.

8.

Replace mower drive belt.

 

9.

Blades improperly installed.

9.

Reinstall blades sharp edge down.

 

10.

Improper blades used.

10.

Replace with blades listed in this manual.

 

11.

Clogged mower deck vent holes from buildup of

11.

Clean around mandrels to open vent holes.

 

 

grass, leaves, and trash around mandrels.

 

 

 

 

 

 

 

Headlight(s) not

1.

Light switch is “OFF”.

1.

Turn light switch “ON”.

working

2.

Bulb(s) or lamp(s) burned out.

2.

Replace bulb(s) or lamp(s).

(if so equipped)

3.

Faulty light switch.

3.

Check/replace light switch.

 

4.

Loose or damaged wiring.

4.

Check wiring and connections.

 

5.

Blown fuse.

5.

Replace fuse.

 

 

 

 

 

Battery will not charge

1.

Bad battery cell(s).

1.

Replace battery.

 

2.

Poor cable connections.

2.

Check/clean all connections.

 

3.

Faulty regulator (if so equipped).

3.

Replace regulator.

 

4.

Faulty alternator.

4.

Replace alternator.

 

 

 

 

 

Loss of drive

1.

Freewheel control in “disengaged” position.

1.

Place freewheel control in “engaged” position.

 

2.

Motion drive belt worn, damaged, or broken.

2.

Replace motion drive belt.

 

3.

Air trapped in transmission during shipment

3.

Purge transmission.

 

 

or servicing.

 

 

 

 

 

 

Engine “backfires”

1.

Engine throttle control not set between half and

1. Move throttle control between half and full speed

when turning

 

full speed (fast) position before stopping engine.

 

(fast) position before stopping engine.

engine “OFF”

 

 

 

 

 

 

 

 

 

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Pbgtge Always Wear EYE Protection During OperationSafety Rules Safe Operation Practices for RIDE-ON MowersGeneral Operation II. Slope OperationSafe Operation Practices for RIDE-ON Mowers III. Children ServiceIV. Towing Table of Contents Unassembled Parts Mower Mower Front WheelSlope Sheet KeysTools Required for Assembly AssemblyTo Remove Tractor from Carton Install Mower and Drive Belt See Figs First Install ANTI-SWAY BAR SAssemble Front Wheel to Mower See Fig7/16 Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To USE Cruise Control -J See FigService REMINDER/HOUR Meter Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance Before Each USEBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install MowerTo Remove Mower See Fig To Level MowerTurn nut right Turn nut left To raise mower To Check Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Engine dies when Page Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PBGTE, 406255 specifications

The Poulan 406255, PBGTE is a powerful and versatile tool designed for home and commercial use, particularly favored for its performance in landscaping and yard maintenance tasks. Known for its reliability, this gas-powered string trimmer combines efficiency with user-friendly features, making it an excellent choice for both novices and experienced users alike.

One of the standout features of the Poulan 406255, PBGTE is its robust 25 cc, 2-cycle gas engine. This powerful engine offers a perfect balance of performance and fuel efficiency, allowing users to tackle tough jobs without frequent refueling. The engine’s design also ensures smoother operation, providing consistent power to the cutting head for a cleaner cut and enhanced productivity.

The trimmer’s lightweight design, weighing in under 10 pounds, enhances maneuverability and reduces user fatigue during extended use. The adjustable handle provides an additional layer of comfort, allowing users to customize the grip for optimal control. This feature is particularly beneficial for extensive trimming sessions, where comfort is paramount to achieving professional results.

Equipped with a dual-line cutting head, the Poulan 406255, PBGTE delivers an impressive cutting width that allows users to cover more ground with fewer passes. The trimmer is designed for easy line replacement, which minimizes downtime. Users can quickly reload the cutting line, ensuring that they can get back to work without delays.

Another notable technology integrated into the Poulan 406255, PBGTE is the Easy Start system. This system simplifies the starting process, making it easier for users to start the engine with minimal effort. As a result, even those unfamiliar with gas-powered tools will appreciate the straightforward functionality of this trimmer.

For maximum safety, the tool includes features such as a protective debris shield, which helps protect the user from flying debris while trimming. The combination of safety aspects and robust performance makes the Poulan 406255, PBGTE a dependable choice for varied landscaping tasks.

In conclusion, the Poulan 406255, PBGTE stands out for its powerful engine, ergonomic design, dual-line cutting head, Easy Start technology, and safety features. This trimmer offers a blend of efficiency, comfort, and safety, making it an essential tool for anyone looking to maintain their outdoor space effectively. Whether you are trimming grass, weeds, or smaller brushes, this trimmer is built to handle the challenge with ease and reliability.
Top Page Image Contents