Poulan 406255, PBGTE manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 26

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANTTO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTUREWHICH LEADSTO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVERTRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Pbgtge Always Wear EYE Protection During OperationGeneral Operation Safety RulesSafe Operation Practices for RIDE-ON Mowers II. Slope OperationIV. Towing ServiceSafe Operation Practices for RIDE-ON Mowers III. Children Table of Contents Slope Sheet Unassembled PartsMower Mower Front Wheel KeysTo Remove Tractor from Carton AssemblyTools Required for Assembly Assemble Front Wheel to Install Mower and Drive Belt See FigsFirst Install ANTI-SWAY BAR S Mower See Fig7/16 Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingSystem Characteristics To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control -J See FigReverse Operation System ROS Service REMINDER/HOUR MeterUsing the Reverse Operation System To Operate on HillsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Maintenance Before Each USEBrake Operation BatteryTractor TiresEngine Muffler CleaningEngine OIL Filter Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower To Level MowerTurn nut right Turn nut left To raise mower To Replace Motion Drive Belt See Fig To Replace Mower Blade Drive BeltTo Check Brake To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Engine dies when Page Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PBGTE, 406255 specifications

The Poulan 406255, PBGTE is a powerful and versatile tool designed for home and commercial use, particularly favored for its performance in landscaping and yard maintenance tasks. Known for its reliability, this gas-powered string trimmer combines efficiency with user-friendly features, making it an excellent choice for both novices and experienced users alike.

One of the standout features of the Poulan 406255, PBGTE is its robust 25 cc, 2-cycle gas engine. This powerful engine offers a perfect balance of performance and fuel efficiency, allowing users to tackle tough jobs without frequent refueling. The engine’s design also ensures smoother operation, providing consistent power to the cutting head for a cleaner cut and enhanced productivity.

The trimmer’s lightweight design, weighing in under 10 pounds, enhances maneuverability and reduces user fatigue during extended use. The adjustable handle provides an additional layer of comfort, allowing users to customize the grip for optimal control. This feature is particularly beneficial for extensive trimming sessions, where comfort is paramount to achieving professional results.

Equipped with a dual-line cutting head, the Poulan 406255, PBGTE delivers an impressive cutting width that allows users to cover more ground with fewer passes. The trimmer is designed for easy line replacement, which minimizes downtime. Users can quickly reload the cutting line, ensuring that they can get back to work without delays.

Another notable technology integrated into the Poulan 406255, PBGTE is the Easy Start system. This system simplifies the starting process, making it easier for users to start the engine with minimal effort. As a result, even those unfamiliar with gas-powered tools will appreciate the straightforward functionality of this trimmer.

For maximum safety, the tool includes features such as a protective debris shield, which helps protect the user from flying debris while trimming. The combination of safety aspects and robust performance makes the Poulan 406255, PBGTE a dependable choice for varied landscaping tasks.

In conclusion, the Poulan 406255, PBGTE stands out for its powerful engine, ergonomic design, dual-line cutting head, Easy Start technology, and safety features. This trimmer offers a blend of efficiency, comfort, and safety, making it an essential tool for anyone looking to maintain their outdoor space effectively. Whether you are trimming grass, weeds, or smaller brushes, this trimmer is built to handle the challenge with ease and reliability.
Top Page Image Contents