Poulan 430092 To Stop Mower Blades, Reverse Operation System ROS See Fig, To Operate on Hills

Page 11

OPERATION

TO STOP MOWER BLADES

•Disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield

(S) in place (See Fig. 10).

S

Fig. 10

REVERSE OPERATION SYSTEM (ROS) (See Fig. 11)

Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless

absolutely necessary.

USING THE REVERSE OPERATION SYSTEM -

Only use if you are certain no children or other bystanders will enter the mowing area.

•Depress brake pedal all the way down.

•With engine running, turn ignition key counterclockwise to ROS "ON" position.

 

 

 

 

 

 

 

 

 

 

8

 

 

0282

ROS "ON" POSITION

ENGINE "ON" POSITION

 

 

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 11

•Look down and behind before and while backing.

•Slowly depress reverse drive pedal to start movement.

•When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

•To restart movement, slowly release parking brake and brake pedal.

•Slowlydepressappropriatedrivepedaltoslowestsetting.

•Make all turns slowly.

TO TRANSPORT (See Figs. 3 and 12)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

•Raise attachment lift to highest position with attachment lift control.

•Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TRANSMISSION ENGAGED

TRANSMISSION DISENGAGED

Fig. 12

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Model PB22H46YTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Toremovetractorfromcarton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation CJK Know Your TractorTo USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Transport See Figs To Stop Mower BladesReverse Operation System ROS See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine Deck Washout Port See Fig CleaningIN-LINE Fuel Filter See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G Turn nut right Turn nut left To raise mower To lower mower To Level MowerTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Remove Wheel See Fig Service and AdjustmentsTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTransmission Engine OIL StorageOther Fuel SystemTroubleshooting Engine continues To run when operBattery will not Fires when turnFold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXStevens Creek Road Terry Fox Way Augusta, GA 30907 USA Outdoor Products Customer Service DeptHOP Canada contactGarantie cette de exclus sont normal l’entretien et Dept Service Customer Products Outdoor Canada AuAutorisé Degrés MAX Moteur le quand ieux Dépannage DE GuidePuissance de Entreposage Sionmistrans Reglages ET RevisionMoteur 33 .Fig Avant Roue LA DE PINCEMENT/CARROSSAGE34 .Fig 32 .Fig Fig LA Voir D’ENTRAÎNEMENT Courroie LA Remplacer PourFig La Voir Tondeuse DE Lame DE Courroie LA Remplacer Pour Freins LES Vérifier Pour28 .Fig Tondeuse LA Niveau LE Ajuster Pour30 .Fig 29 .Fig22 .Fig 26 .Fig25 .Fig 23 .FigGaged Fig VoirTondeuse LA Enlever Pour 21 .FigFig la Voir Ligne EN Installe Dessence FiltreEntretien Fig La Voir Coupe DE Plateau DU Lavage DE RaccordMoteur DE L’HUILE Changer Pour ’ALLUMAGE BougieVentilation DE Système ’AIR Tamis LE NettoyerFrein DU Fonctionnement Fig la Voir Lame LA EnleverLames DES Entretien PneusCe de Réglages et Etretien section la dans réglages les Tous Utilisation Chaque Avant13 .Fig Avant ET Réinstallation LA Après Purgée ÊtreUtilisation Transmission LA PurgerQueti Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierPentes LES Dans Utiliser Pour Accessoires Autres ET Charrettes DES Remorquer PourTondeuse DE Lames LES Arrêter Pour Tracteur LE Transporter PourJauge DE Roues LES Régler Pour Fig la Voir J- Vitess DE Régulateur LE Utiliser CommentFig la Tondeuse LA Utiliser PourTondeuse DE Lames GAZ DES Commande LA Utiliser PourFig la Voir D Fig la Voir Mentnetionsta DE Frein LE Engager PourUtilisation Frein DE Pédale Tionsec la Voir Rouler Faisant LE EN TE MontageDesmancom des fonction la et Clés pente-Guide Assemblé PAS PiècesFig la Voir Siège LE Ajustez Fig la Voir Batterie LA VérifierSL-SG-API U1R DimensionSommaire CCA .MIN AMP/HREntretien Sécurité DE RèglesEnfants Tracteurs des sécurité toute en l’utilisation pour ConseilsVeuillezlire,comprendreetsuivrelesinstructionsquevoustrou Pentes LES Dans FonctionnementGénéral Fonctionnement ’éboule bord le si précipiter de ou bordAvertissement REV

96042010800, 430092 specifications

The Poulan 430092, also known by its part number 96042010800, is a high-performance chainsaw that caters to both professional landscapers and homeowners who require a reliable tool for various cutting tasks. Known for its durability, versatility, and user-friendly design, it stands out as a go-to choice in the realm of outdoor equipment.

One of the most notable features of the Poulan 430092 is its powerful engine. Equipped with a robust 40cc two-stroke engine, this chainsaw delivers ample power for cutting through tough wood and handling larger tasks with ease. The engine’s design promotes efficient fuel consumption, allowing for longer use between refueling sessions. This is particularly beneficial for users who need to complete extensive projects without frequent interruptions.

Another characteristic that sets the Poulan 430092 apart is its lightweight design. Weighing under 12 pounds, the chainsaw is easy to maneuver, making it ideal for both aerial pruning and ground-level cutting. Its ergonomic handle provides comfort during extended use, helping to reduce fatigue. Additionally, the chainsaw features an anti-vibration system that absorbs shock, further enhancing user comfort.

The chainsaw is equipped with a 16-inch guide bar and chain, allowing for a greater cutting capacity and making it well-suited for tackling medium to large-sized trees and logs. Its low kickback chain enhances safety, providing peace of mind when operating the saw.

The Poulan 430092 also incorporates advanced technologies such as an automatic oiling system, which ensures that the chain remains well-lubricated during operation. This system prevents excessive wear and tear and prolongs the life of the chainsaw. The easy-access air filter is another innovative feature, allowing users to quickly clean or replace the filter, which helps to maintain optimal engine performance.

In terms of safety, the chainsaw comes with a safety switch that prevents accidental starting, and the chain brake offers additional protection by stopping the chain in case of kickback. These features make the Poulan 430092 not only efficient but also safe for users of all experience levels.

Overall, the Poulan 430092,96042010800 is a reliable and powerful chainsaw that provides excellent performance, user-friendly features, and advanced technologies, making it an excellent investment for anyone needing a dependable cutting tool. Its combination of power, safety, and efficiency continues to earn it a solid reputation in the market for outdoor power equipment.
Top Page Image Contents