Poulan 96042010800 Service and Adjustments, Front Wheel TOE-IN/CAMBER, To Remove Wheel See Fig

Page 22

SERVICE AND ADJUSTMENTS

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL (See Fig. 33)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 33

TO START ENGINE WITH A WEAK BATTERY (See Fig. 34)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WEAK OR DEAD

 

 

FULLY CHARGED

BATTERY

 

 

BATTERY

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Fig. 34

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents PB22H46YT ModelGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Unassembled Parts AssemblyTools Required for Assembly ToremovetractorfromcartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor CJKStopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control J See FigTo Operate on Hills To Stop Mower BladesReverse Operation System ROS See Fig To Transport See FigsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionGeneral Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Turn nut right Turn nut left To raise mower To lower mowerTo Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER Service and AdjustmentsTo Start Engine with a Weak Battery See Fig To Remove Wheel See FigTransmission Fuel System StorageOther Engine OILTroubleshooting Fires when turn To run when operBattery will not Engine continuesOnly Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeCanada contact Outdoor Products Customer Service DeptHOP Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAAutorisé Dept Service Customer Products Outdoor Canada AuGarantie cette de exclus sont normal l’entretien et Degrés MAX Dépannage DE Guide Moteur le quand ieuxPuissance de Entreposage Moteur Reglages ET RevisionSionmistrans 34 .Fig Avant Roue LA DE PINCEMENT/CARROSSAGE33 .Fig Freins LES Vérifier Pour Fig LA Voir D’ENTRAÎNEMENT Courroie LA Remplacer PourFig La Voir Tondeuse DE Lame DE Courroie LA Remplacer Pour 32 .Fig29 .Fig Tondeuse LA Niveau LE Ajuster Pour30 .Fig 28 .Fig23 .Fig 26 .Fig25 .Fig 22 .Fig21 .Fig Fig VoirTondeuse LA Enlever Pour GagedFig La Voir Coupe DE Plateau DU Lavage DE Raccord Ligne EN Installe Dessence FiltreEntretien Fig la Voir’AIR Tamis LE Nettoyer ’ALLUMAGE BougieVentilation DE Système Moteur DE L’HUILE Changer PourPneus Fig la Voir Lame LA EnleverLames DES Entretien Frein DU FonctionnementUtilisation Chaque Avant Ce de Réglages et Etretien section la dans réglages les TousTransmission LA Purger Avant ET Réinstallation LA Après Purgée ÊtreUtilisation 13 .FigMoteur DU D’HUILE Niveau LE Vérifier Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir QuetiTracteur LE Transporter Pour Accessoires Autres ET Charrettes DES Remorquer PourTondeuse DE Lames LES Arrêter Pour Pentes LES Dans Utiliser PourTondeuse LA Utiliser Pour Fig la Voir J- Vitess DE Régulateur LE Utiliser CommentFig la Jauge DE Roues LES Régler PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourFig la Voir D Tondeuse DE LamesUtilisation Frein DE Pédale Desmancom des fonction la et MontageTionsec la Voir Rouler Faisant LE EN TE Fig la Voir Batterie LA Vérifier Assemblé PAS PiècesFig la Voir Siège LE Ajustez Clés pente-GuideCCA .MIN AMP/HR U1R DimensionSommaire SL-SG-APITracteurs des sécurité toute en l’utilisation pour Conseils Sécurité DE RèglesEnfants Entretien’éboule bord le si précipiter de ou bord Pentes LES Dans FonctionnementGénéral Fonctionnement Veuillezlire,comprendreetsuivrelesinstructionsquevoustrouREV Avertissement

96042010800, 430092 specifications

The Poulan 430092, also known by its part number 96042010800, is a high-performance chainsaw that caters to both professional landscapers and homeowners who require a reliable tool for various cutting tasks. Known for its durability, versatility, and user-friendly design, it stands out as a go-to choice in the realm of outdoor equipment.

One of the most notable features of the Poulan 430092 is its powerful engine. Equipped with a robust 40cc two-stroke engine, this chainsaw delivers ample power for cutting through tough wood and handling larger tasks with ease. The engine’s design promotes efficient fuel consumption, allowing for longer use between refueling sessions. This is particularly beneficial for users who need to complete extensive projects without frequent interruptions.

Another characteristic that sets the Poulan 430092 apart is its lightweight design. Weighing under 12 pounds, the chainsaw is easy to maneuver, making it ideal for both aerial pruning and ground-level cutting. Its ergonomic handle provides comfort during extended use, helping to reduce fatigue. Additionally, the chainsaw features an anti-vibration system that absorbs shock, further enhancing user comfort.

The chainsaw is equipped with a 16-inch guide bar and chain, allowing for a greater cutting capacity and making it well-suited for tackling medium to large-sized trees and logs. Its low kickback chain enhances safety, providing peace of mind when operating the saw.

The Poulan 430092 also incorporates advanced technologies such as an automatic oiling system, which ensures that the chain remains well-lubricated during operation. This system prevents excessive wear and tear and prolongs the life of the chainsaw. The easy-access air filter is another innovative feature, allowing users to quickly clean or replace the filter, which helps to maintain optimal engine performance.

In terms of safety, the chainsaw comes with a safety switch that prevents accidental starting, and the chain brake offers additional protection by stopping the chain in case of kickback. These features make the Poulan 430092 not only efficient but also safe for users of all experience levels.

Overall, the Poulan 430092,96042010800 is a reliable and powerful chainsaw that provides excellent performance, user-friendly features, and advanced technologies, making it an excellent investment for anyone needing a dependable cutting tool. Its combination of power, safety, and efficiency continues to earn it a solid reputation in the market for outdoor power equipment.
Top Page Image Contents