Poulan 96042006900 Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 18

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

•Depress brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 17)

•Place attachment clutch in “DISENGAGED” position.

•Lower attachment lift lever to its lowest position.

•Roll belt off engine pulley (M) and belt keepers (G).

•Remove retainer spring (K), slide collar (L) off and push housing guide (P) out of bracket.

•Remove clutch cable spring (Q) from idler arm (R).

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Go to either side of mower and disconnect mower suspension arm (A) from chassis pin (B) and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

CAUTION: AFTER REAR LIFT LINKS

ARE DISCONNECTED, THE ATTACH-

MENT LIFT LEVER WILL BE SPRING

LOADED. HAVE A TIGHT GRIP ON LIFT

LEVER WHEN CHANGING POSITION

OF THE LEVER.

•Slide mower out from under right side of tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE

MOWER IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINK (E) AND REAR LIFT LIKS

(C)FROM TRACTOR AND HOOK THE CLUTCH SPRING

(Q)INTO THE CABLE GUIDE ON FRONT EDGE OF LOWER DASH.

TO INSTALL MOWER (See Fig. 18–21)

Be sure tractor is on level surface and engage parking brake.

•Lower attachment lift lever to it's lowest position.

CAUTION: LIFT LEVER IS SPRING

LOADED. HAVE A TIGHT GRIP ON

LIFT LEVER, LOWER IT SLOWLY AND

ENGAGE IN LOWEST POSITION.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

•ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

•Repeat on opposite side of tractor.

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D)

G MF

Q R

G

P

A E

B

C

K

D

 

L

FIG. 17

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents PB22H46YTX General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationService III. ChildrenIV. Towing Table of Contents To Remove Tractor from Carton AssemblyUnassembled Parts Unpack CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor System Characteristics To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerReverse Operation System ROS Service REMINDER/HOUR MeterBefore Starting the Engine To Operate on HillsPurge Transmission ADD GasolineTo Start Engine See Fig Automatic Transmission Warm UPMowing Tips Maintenance Lubrication ChartBrake Operation BatteryTractor TiresEngine Muffler CleaningEngine OIL Filter Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Mower Drive Belt To Check and Adjust Brake See FigTo Adjust Brake To Check BrakeFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigTo Replace Motion Drive Belt See Fig To Remove Wheel for Repairs See FigTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Engine dies when Limited Warranty Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Service and Parts Suggested Guide for Sighting Slopes for Safe Operation Page Warranty Limited Points Troubleshooting Fuel in Water Other TractorOIL Engine Assembly Grill and Hood Remove to Adjustments and ServiceCarburetor Adjust to Trolcon Choke Justad toBERIN/CAM-TOE Wheel Front Fig See Battery Weak a with Engine Start toRepairs for Wheel Remove to Belt Drive Motion Replace to27 .FIG Brake Adjust and Check toBelt Drive Mower Replace to 26 .FIG24 .FIG Mower Level to25 .FIG 23 .FIGRouting Proper for Belt Check Important 21 .FIG 19 .FIGGrooves Pulley Mower ALL 20 .FIGFig See Mower Install to Fig See Mower Remove to17 .FIG Plugs Spark CleaningFig See Filter Fuel LINE-IN MufflerFilter AIR Cooling TransaxleTires Fig See Removal BladeCare Blade Operation BrakeSchedule MaintenanceRecommendations General USE Each BeforeTips Mowing 12 .FIGGasoline ADD Transmission PurgeFig See Engine Start to UP Warm Transmission AutomaticLevel OIL Engine Check Meter REMINDER/HOUR ServiceEngine the Starting Before 3 .Figs See Transport toCharacteristics System Fig See Wheels Gauge Adjust toHeight Tingcut Mower Adjust to Mower Operate toTortrac Your USE to HOW Backward and Forward Move toOperation Only Models Automatic Wheel Free Function and location for section tionaer ALL of Position Proper for CheckTrolscon Op See Skid OFF Tortrac Drive toToncar from Tractor Remove to Fig See Seat AdjustParts Unassembled Op See Skid OFF Tractor Roll toContents of Table Towing Rules SafetyMowers On-Ride for ChildrenOperation Slope Operation GeneralMowers On-Ride for Practices Operation Safe Tractor Lawn PB22H46YTX Model Manual Operators

418774, PB22H46YTX, 96042006900 specifications

The Poulan 418774, also known by its model number 96042006900, is a robust and versatile lawn tractor that caters to homeowners and lawn care enthusiasts alike. Designed for residential use, the PB22H46YTX offers a host of features that enhance its performance, comfort, and efficiency, making it an excellent option for maintaining medium to large-sized lawns.

One of the standout characteristics of the Poulan PB22H46YTX is its powerful 22-horsepower Briggs & Stratton engine. This reliable engine provides ample power to tackle various terrain types and allows for effective mowing, even in challenging conditions. One of the engine's key features is its overhead valve design, which promotes better fuel efficiency and reduces emissions, aligning with modern environmental standards.

The PB22H46YTX comes equipped with a 46-inch cutting deck, which is ideal for larger mowing areas. This wide cutting swath allows users to cover more ground in less time, significantly reducing the time spent on yard maintenance. The cutting deck also features an adjustable height range, giving users the flexibility to choose the optimal grass length for their specific lawn care needs.

Another significant feature of the Poulan PB22H46YTX is its hydrostatic transmission. This technology allows for seamless speed adjustments, offering a smoother driving experience without the need for gear shifting. Users can easily maneuver the tractor across the yard, making it easier to navigate around trees, flower beds, and other obstacles.

In terms of comfort, the PB22H46YTX includes a spacious operator's seat with ergonomic design, ensuring optimal support during extended periods of use. The dashboard is user-friendly, providing easy access to essential controls and information, including engine status and speed.

Durability is another hallmark of the Poulan brand, and the PB22H46YTX is built to last. It features a reinforced steel frame and heavy-duty tires, providing stability and traction on various surfaces. Additionally, the cutting blades are designed for longevity and can handle tough grass conditions with ease.

Overall, the Poulan 418774, 96042006900, and PB22H46YTX model offers an ideal blend of power, comfort, and advanced features, making it a top choice for anyone looking to maintain their lawn effortlessly and efficiently.
Top Page Image Contents