Poulan 418774, 96042006900 manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

WEAK OR DEAD

FULLY CHARGED

BATTERY

BATTERY

FIG. 30

REPLACING BATTERY (See Fig. 31)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent spark- ing from accidental grounding.

•Lift hood to raised position.

•Disconnect BLACK battery cable (A) then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable (B) to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover (C) over terminal.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely

•Close hood.

A Negative(Black)

Cable

C

Positive B (Red) Cable

02954

FIG. 31

23

 

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 32)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

03075

FIG. 32

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

Page 22 Page 24
Image 23
Page 22 Page 24
Contents PB22H46YTX II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Reverse Operation System ROS on Position Know Your TractorHOW to USE Your Tractor To Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsTo Operate on Hills Service REMINDER/HOUR MeterBefore Starting the Engine Reverse Operation System ROSAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Lubrication Chart MaintenanceTires BatteryTractor Brake OperationEngine Spark Plugs CleaningEngine OIL Filter MufflerTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Check and Adjust Brake See FigTo Adjust Brake To Replace Mower Drive BeltTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Engine dies when Limited Warranty Service Notes Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Service and Parts Suggested Guide for Sighting Slopes for Safe Operation Page Warranty Limited Points Troubleshooting Fuel in Water OIL Engine OtherTractor Trolcon Choke Justad to Adjustments and ServiceCarburetor Adjust to Assembly Grill and Hood Remove toBelt Drive Motion Replace to Fig See Battery Weak a with Engine Start toRepairs for Wheel Remove to BERIN/CAM-TOE Wheel Front26 .FIG Brake Adjust and Check toBelt Drive Mower Replace to 27 .FIG23 .FIG Mower Level to25 .FIG 24 .FIG20 .FIG 21 .FIG 19 .FIGGrooves Pulley Mower ALL Routing Proper for Belt Check Important17 .FIG Fig See Mower Install toFig See Mower Remove to Muffler CleaningFig See Filter Fuel LINE-IN Plugs SparkCooling Transaxle Filter AIROperation Brake Fig See Removal BladeCare Blade TiresUSE Each Before MaintenanceRecommendations General Schedule12 .FIG Tips MowingUP Warm Transmission Automatic Transmission PurgeFig See Engine Start to Gasoline ADD3 .Figs See Transport to Meter REMINDER/HOUR ServiceEngine the Starting Before Level OIL Engine CheckMower Operate to Fig See Wheels Gauge Adjust toHeight Tingcut Mower Adjust to Characteristics SystemBackward and Forward Move to Tortrac Your USE to HOWOperation Only Models Automatic Wheel Free Op See Skid OFF Tortrac Drive to ALL of Position Proper for CheckTrolscon Function and location for section tionaerOp See Skid OFF Tractor Roll to Fig See Seat AdjustParts Unassembled Toncar from Tractor Remove toContents of Table Children Rules SafetyMowers On-Ride for TowingMowers On-Ride for Practices Operation Safe Operation SlopeOperation General Tractor Lawn PB22H46YTX Model Manual Operators

418774, PB22H46YTX, 96042006900 specifications

The Poulan 418774, also known by its model number 96042006900, is a robust and versatile lawn tractor that caters to homeowners and lawn care enthusiasts alike. Designed for residential use, the PB22H46YTX offers a host of features that enhance its performance, comfort, and efficiency, making it an excellent option for maintaining medium to large-sized lawns.

One of the standout characteristics of the Poulan PB22H46YTX is its powerful 22-horsepower Briggs & Stratton engine. This reliable engine provides ample power to tackle various terrain types and allows for effective mowing, even in challenging conditions. One of the engine's key features is its overhead valve design, which promotes better fuel efficiency and reduces emissions, aligning with modern environmental standards.

The PB22H46YTX comes equipped with a 46-inch cutting deck, which is ideal for larger mowing areas. This wide cutting swath allows users to cover more ground in less time, significantly reducing the time spent on yard maintenance. The cutting deck also features an adjustable height range, giving users the flexibility to choose the optimal grass length for their specific lawn care needs.

Another significant feature of the Poulan PB22H46YTX is its hydrostatic transmission. This technology allows for seamless speed adjustments, offering a smoother driving experience without the need for gear shifting. Users can easily maneuver the tractor across the yard, making it easier to navigate around trees, flower beds, and other obstacles.

In terms of comfort, the PB22H46YTX includes a spacious operator's seat with ergonomic design, ensuring optimal support during extended periods of use. The dashboard is user-friendly, providing easy access to essential controls and information, including engine status and speed.

Durability is another hallmark of the Poulan brand, and the PB22H46YTX is built to last. It features a reinforced steel frame and heavy-duty tires, providing stability and traction on various surfaces. Additionally, the cutting blades are designed for longevity and can handle tough grass conditions with ease.

Overall, the Poulan 418774, 96042006900, and PB22H46YTX model offers an ideal blend of power, comfort, and advanced features, making it a top choice for anyone looking to maintain their lawn effortlessly and efficiently.
Top Page Image Contents