Poulan 418774, 96042006900, PB22H46YTX manual To Level Mower

Page 20

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 22)

•With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower.

NOTE: As desired, you can raise the low side of mower or lower the high side.

•Go to side of mower you wish to adjust.

•With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower the mower, or, to the right to raise the mower.

A

Turn nut right

Turn nut left

to raise mower

to lower mower

02948

FIG. 22

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

•Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 23)

•With all tires properly inflated, park tractor on level ground or driveway.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to its highest position.

•At both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides.

•If adjustment is necessary, see steps in Visual Adjust- ment instructions above.

•Recheck measurements, adjust if necessary until both sides are equal.

 

02966

A

A

FIG. 23

FRONT-TO-BACK ADJUSTMENT (See Figs. 24 and 25) IMPORTANT: Deck must be level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to highest position.

•Position any blade so the tip is pointing straight forward. Measure distance (B) to the ground at front and rear tip of the blade.

•If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.

•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.

•With a 3/4" or adjustable wrench, turn front link adjust- ment nut (B) clockwise (ltighten) to raise the front of mower, or, counterclockwise (loosen) to lower the front mower.

02548

BB

FIG. 24

B

A

Tighten adjust nut

Loosen adjust nut

B to raise mower

B to lower mower

02950

Loosen jam nut A first

FIG. 25

NOTE: Each full turn of the adjustment nut will change mower height about 1/8".

•Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lower than the rear tip.

20• Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.

Page 19 Page 21
Image 20
Page 19 Page 21
Contents PB22H46YTX Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationIV. Towing ServiceIII. Children Table of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor To Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerService REMINDER/HOUR Meter Before Starting the EngineReverse Operation System ROS To Operate on HillsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance Lubrication ChartBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check and Adjust Brake See Fig To Adjust BrakeTo Replace Mower Drive Belt To Check BrakeTo Start Engine with a Weak Battery See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Engine dies when Limited Warranty Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Service and Parts Suggested Guide for Sighting Slopes for Safe Operation Page Warranty Limited Points Troubleshooting Fuel in Water OIL Engine OtherTractor Adjustments and Service Carburetor Adjust toAssembly Grill and Hood Remove to Trolcon Choke Justad toFig See Battery Weak a with Engine Start to Repairs for Wheel Remove toBERIN/CAM-TOE Wheel Front Belt Drive Motion Replace toBrake Adjust and Check to Belt Drive Mower Replace to27 .FIG 26 .FIGMower Level to 25 .FIG24 .FIG 23 .FIG21 .FIG 19 .FIG Grooves Pulley Mower ALLRouting Proper for Belt Check Important 20 .FIG17 .FIG Fig See Mower Install toFig See Mower Remove to Cleaning Fig See Filter Fuel LINE-INPlugs Spark MufflerFilter AIR Cooling TransaxleFig See Removal Blade Care BladeTires Operation BrakeMaintenance Recommendations GeneralSchedule USE Each BeforeTips Mowing 12 .FIGTransmission Purge Fig See Engine Start toGasoline ADD UP Warm Transmission AutomaticMeter REMINDER/HOUR Service Engine the Starting BeforeLevel OIL Engine Check 3 .Figs See Transport toFig See Wheels Gauge Adjust to Height Tingcut Mower Adjust toCharacteristics System Mower Operate toTortrac Your USE to HOW Backward and Forward Move toOperation Only Models Automatic Wheel Free ALL of Position Proper for Check TrolsconFunction and location for section tionaer Op See Skid OFF Tortrac Drive toFig See Seat Adjust Parts UnassembledToncar from Tractor Remove to Op See Skid OFF Tractor Roll toContents of Table Rules Safety Mowers On-Ride forTowing ChildrenMowers On-Ride for Practices Operation Safe Operation SlopeOperation General Tractor Lawn PB22H46YTX Model Manual Operators

418774, PB22H46YTX, 96042006900 specifications

The Poulan 418774, also known by its model number 96042006900, is a robust and versatile lawn tractor that caters to homeowners and lawn care enthusiasts alike. Designed for residential use, the PB22H46YTX offers a host of features that enhance its performance, comfort, and efficiency, making it an excellent option for maintaining medium to large-sized lawns.

One of the standout characteristics of the Poulan PB22H46YTX is its powerful 22-horsepower Briggs & Stratton engine. This reliable engine provides ample power to tackle various terrain types and allows for effective mowing, even in challenging conditions. One of the engine's key features is its overhead valve design, which promotes better fuel efficiency and reduces emissions, aligning with modern environmental standards.

The PB22H46YTX comes equipped with a 46-inch cutting deck, which is ideal for larger mowing areas. This wide cutting swath allows users to cover more ground in less time, significantly reducing the time spent on yard maintenance. The cutting deck also features an adjustable height range, giving users the flexibility to choose the optimal grass length for their specific lawn care needs.

Another significant feature of the Poulan PB22H46YTX is its hydrostatic transmission. This technology allows for seamless speed adjustments, offering a smoother driving experience without the need for gear shifting. Users can easily maneuver the tractor across the yard, making it easier to navigate around trees, flower beds, and other obstacles.

In terms of comfort, the PB22H46YTX includes a spacious operator's seat with ergonomic design, ensuring optimal support during extended periods of use. The dashboard is user-friendly, providing easy access to essential controls and information, including engine status and speed.

Durability is another hallmark of the Poulan brand, and the PB22H46YTX is built to last. It features a reinforced steel frame and heavy-duty tires, providing stability and traction on various surfaces. Additionally, the cutting blades are designed for longevity and can handle tough grass conditions with ease.

Overall, the Poulan 418774, 96042006900, and PB22H46YTX model offers an ideal blend of power, comfort, and advanced features, making it a top choice for anyone looking to maintain their lawn effortlessly and efficiently.
Top Page Image Contents