Poulan 96042006900, 418774 Mower Operate to, Fig See Wheels Gauge Adjust to, Blades Mower Stop to

Page 51

10 .FIG

S

.place in (S) shield

 

deflector the or equipped, so mowers on

 

catcher, grass tireen the either without

 

mower the operate not Do CAUTION:

 

.trolcon clutch menttachat disengage

- BLADES MOWER STOP TO

.control

 

clutch menttachat engaging by blades mower Start

•

.lever lift attachment with cut of height desired Select

•

.hills or terrain rolling

rough, on equipment your operating when off cutting or

hesitating from engine the prevent to seat the in positioned

centrally and fully remain must You .engine the off shut will

engaged clutch attachment the and running engine the

with seat the leave to operator the by attempt Any .switch

sensing presence operator an with equipped is tractor Your

MOWER OPERATE TO

10

.height siredde to second the high; relatively

 

cut first the Make .twice mowed be should height in

 

inches 6 over grass performance, cutting best For

•

.growth moderate after and often mow lawns,

 

looking better and healthier For .months hot during

 

inches 3 over to and season cool the during inches

 

1/2-2 approximately to cut be should lawn average The

•

.mowed being grass of types and grass

of height conditions, soil upon depending vary may and

approximate are heights These .running not engine the

with tip blade the to ground the from measured are heights

The .4" to 1" lymateiproxap is range height cutting The

.slot height cutting desired in lever lift attachment Put

•

8 .FIG

 

A

9.FIG

.hole ment

 

-adjust same in wheel gauge installing all, for Repeat

•

.lycurese Tighten

 

.hole atepriproap in wheel gauge stallIn .ground the

 

off slightly are they so assembled be should wheels

 

gauge tion,sipo cut of height desired in mower With

•

.manual)

 

of tionsec this in HEIGHT” TINGCUT MOWER JUST

 

-AD “TO (See height cutting desired to mower Adjust

•

.surface

level flat a on tractor with wheels gauge Adjust NOTE:

.conditions

terrain most in scalping prevent help to position proper in

deck the keep then wheels Gauge .position operating in

height cutting desired the at is mower when ground the off

lyslight are they when edjustad lyerprop are wheels Gauge

9) .Fig (See WHEELS GAUGE ADJUST TO

.height tingcut the minesterde (A) verle lift menttachat the of tionsipo The

 

8) .Fig (See

HEIGHT TINGCUT MOWER ADJUST TO

 

.pedal drive forward on tap or

pedal brake the depress control, cruise the disengage To

.lever the release then pedal, the off foot your

 

lifting while hold and up (J) lever control cruise pull

 

speed, desired to depressed pedal drive forward With

•

.turning or trimmimg while or terrian rough slopes, on

control cruise the use not Do .gageendis to control cruise

the cause may speeds slow at trimming as such tionsdicon

Other .surfaces straight smooth, relatively on transporting

or mowing while used be only should control cruise The

 

CHARACTERISTICS SYSTEM

 

7 .FIG

 

 

 

L

 

 

K

 

J

OPERATION

Page 50 Page 52
Image 51
Page 50 Page 52
Contents PB22H46YTX II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationService III. ChildrenIV. Towing Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Reverse Operation System ROS on Position Know Your TractorHOW to USE Your Tractor To Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsTo Operate on Hills Service REMINDER/HOUR MeterBefore Starting the Engine Reverse Operation System ROSAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Lubrication Chart MaintenanceTires BatteryTractor Brake OperationEngine Spark Plugs CleaningEngine OIL Filter MufflerService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Check Brake To Check and Adjust Brake See FigTo Adjust Brake To Replace Mower Drive BeltTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Engine dies when Limited Warranty Service Notes Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Service and Parts Suggested Guide for Sighting Slopes for Safe Operation Page Warranty Limited Points Troubleshooting Fuel in Water Other TractorOIL Engine Trolcon Choke Justad to Adjustments and ServiceCarburetor Adjust to Assembly Grill and Hood Remove toBelt Drive Motion Replace to Fig See Battery Weak a with Engine Start toRepairs for Wheel Remove to BERIN/CAM-TOE Wheel Front26 .FIG Brake Adjust and Check toBelt Drive Mower Replace to 27 .FIG23 .FIG Mower Level to25 .FIG 24 .FIG20 .FIG 21 .FIG 19 .FIGGrooves Pulley Mower ALL Routing Proper for Belt Check ImportantFig See Mower Install to Fig See Mower Remove to17 .FIG Muffler CleaningFig See Filter Fuel LINE-IN Plugs SparkCooling Transaxle Filter AIROperation Brake Fig See Removal BladeCare Blade TiresUSE Each Before MaintenanceRecommendations General Schedule12 .FIG Tips MowingUP Warm Transmission Automatic Transmission PurgeFig See Engine Start to Gasoline ADD3 .Figs See Transport to Meter REMINDER/HOUR ServiceEngine the Starting Before Level OIL Engine CheckMower Operate to Fig See Wheels Gauge Adjust toHeight Tingcut Mower Adjust to Characteristics SystemBackward and Forward Move to Tortrac Your USE to HOWOperation Only Models Automatic Wheel Free Op See Skid OFF Tortrac Drive to ALL of Position Proper for CheckTrolscon Function and location for section tionaerOp See Skid OFF Tractor Roll to Fig See Seat AdjustParts Unassembled Toncar from Tractor Remove toContents of Table Children Rules SafetyMowers On-Ride for TowingOperation Slope Operation GeneralMowers On-Ride for Practices Operation Safe Tractor Lawn PB22H46YTX Model Manual Operators

418774, PB22H46YTX, 96042006900 specifications

The Poulan 418774, also known by its model number 96042006900, is a robust and versatile lawn tractor that caters to homeowners and lawn care enthusiasts alike. Designed for residential use, the PB22H46YTX offers a host of features that enhance its performance, comfort, and efficiency, making it an excellent option for maintaining medium to large-sized lawns.

One of the standout characteristics of the Poulan PB22H46YTX is its powerful 22-horsepower Briggs & Stratton engine. This reliable engine provides ample power to tackle various terrain types and allows for effective mowing, even in challenging conditions. One of the engine's key features is its overhead valve design, which promotes better fuel efficiency and reduces emissions, aligning with modern environmental standards.

The PB22H46YTX comes equipped with a 46-inch cutting deck, which is ideal for larger mowing areas. This wide cutting swath allows users to cover more ground in less time, significantly reducing the time spent on yard maintenance. The cutting deck also features an adjustable height range, giving users the flexibility to choose the optimal grass length for their specific lawn care needs.

Another significant feature of the Poulan PB22H46YTX is its hydrostatic transmission. This technology allows for seamless speed adjustments, offering a smoother driving experience without the need for gear shifting. Users can easily maneuver the tractor across the yard, making it easier to navigate around trees, flower beds, and other obstacles.

In terms of comfort, the PB22H46YTX includes a spacious operator's seat with ergonomic design, ensuring optimal support during extended periods of use. The dashboard is user-friendly, providing easy access to essential controls and information, including engine status and speed.

Durability is another hallmark of the Poulan brand, and the PB22H46YTX is built to last. It features a reinforced steel frame and heavy-duty tires, providing stability and traction on various surfaces. Additionally, the cutting blades are designed for longevity and can handle tough grass conditions with ease.

Overall, the Poulan 418774, 96042006900, and PB22H46YTX model offers an ideal blend of power, comfort, and advanced features, making it a top choice for anyone looking to maintain their lawn effortlessly and efficiently.
Top Page Image Contents