Poulan PB175H42LT manual Before Starting the Engine, To Transport See Figs, Check Engine OIL Level

Page 13

OPERATION

TO TRANSPORT (See Figs. 4 and 8)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

•Raise attachment lift to highest position with attachment lift control.

•Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above proce- dure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

Transmission Engaged

Transmission Disengaged

FIG. 8

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

•The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 4)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place motion control lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents PB18H42LT ModelSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Steering Wheel Seat Unassembled PartsSlope Sheet Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsTo Transport See Figs Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP NingLubrication Chart MaintenanceBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine Clean AIR Screen CleaningAIR Filter MufflerTo Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal Transaxle Motion Control Lever Neutral Adjustment See Fig To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when L5V 3E4 Limited WarrantyService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Dentretien Notes Garantie cette de exclus sont normal l’entretien et AutoriséCorrection Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Moteur EntreposageTracteur Carburateur LE Régler Pour Reglages ET Revision27 et 26 .Fig les Voir Batterie LA ReplacerRossage LA DE ENLEVEMENT/REMPLACEMENTAVANT/CAR Roues DES Convergence LA DE L’ALIGNEMENT Régler Pour’EN Courroie LA Remplacer Pour Fig la VoirFrein LE Régler ET Contrôler Pour Transmission DE MentnetraîTondeuse DE Lame DE MENTNETRAÎD’EN Courroie Acer Rempl Pour15 .FIG Tondeuse DE Boîtier LE Niveler PourLautre À Côté DUN Réglage Moteur EntretienTransmission LA DE Refroidissement Sionmistrans LA DE Moteur FluideFig la Voir Lame LA Affiler Trapézoïdales CourroiesEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverGénérales Recommandations LESLubrification DE Tableau Utilisation Chaque AvantTondre DE Conseils UtilisationTransmission LA Purger QuetiMoteur LE Démarrer DE Avant EN Fonctionnement DE Système Et 4 .Fig les VoirTracteur LE Transporter Pour Pentes LES Dans Utiliser PourTeurtrac Votre Utiliser Comment GAZ DES Commande LA Utiliser PourFig la Voir Arrêter Pour Fig la Voir Mentnetionsta DE Frein LE Engager PourLSW02838 ’EMBRAYAGE NI DE EST Tondeuse LA SI Vérifier MontagePA LA DE Tracteur LE Retirer Pour DU Tracteur LE Sortir Pour Fig la Voir Siège LE InstallerPalette LA ToncarPente-Guide Montées NON PiécesClés Siège Direction de VolantClient DU Responsabilités SommaireProduit DE Spécifications Remorquage EntretienEnfants Général EntretienPEN LES Dans Fonctionnement TESGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé ModèleAvertissement

PB175H42LT specifications

The Poulan PB175H42LT is a robust lawn tractor designed for homeowners seeking an efficient and reliable solution for lawn maintenance. With a focus on power, comfort, and versatility, this model stands out as a great option for handling a variety of mowing tasks.

One of the key features of the PB175H42LT is its powerful 17.5 HP Briggs & Stratton engine. This engine offers reliable starting and performance, making it suitable for tackling both small and large yards. The automatic hydrostatic transmission enhances the driving experience by providing a smooth and effortless change of speed without the need for shifting gears. This means users can focus more on mowing rather than managing complicated controls.

The 42-inch cutting deck of the Poulan PB175H42LT is designed for efficiency and precision. With its three-blade system, it delivers an even and clean cut, reducing the number of passes needed to achieve a well-manicured lawn. The deck is also adjustable, allowing users to set their desired cutting height between 1.5 to 4 inches, catering to various grass types and preferences.

Comfort is a priority with the PB175H42LT, which features a comfortable high back seat and easy-to-reach controls. The tractor's design also includes a tight turning radius, making it easy to navigate around flower beds and trees. Additionally, the generous legroom and ergonomic layout ensure that users can operate the tractor for extended periods without discomfort.

The Poulan PB175H42LT incorporates several technologies that enhance its functionality. For example, the Easy Start technology allows for quick engine ignition, so users can get started with their mowing tasks without delay. The integrated mulching capability provides added versatility, enabling homeowners to fertilize their lawns naturally while maintaining a tidy appearance.

Durability is another hallmark of the Poulan brand, and the PB175H42LT is built to last. Its heavy-duty construction ensures that the tractor can withstand regular use and varying conditions, making it a solid investment for any homeowner.

In summary, the Poulan PB175H42LT is a well-designed lawn tractor that combines power, comfort, and advanced features. Its reliable engine, adjustable cutting deck, and user-friendly controls make it an excellent choice for maintaining a beautiful lawn with ease. Whether tackling tough weeds or managing routine mowing, this model delivers the performance and reliability homeowners need.
Top Page Image Contents