Poulan PB175H42LT Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 19

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

Depress clutch/brake pedal fully and set parking brake.

Place motion control lever in neutral (N) position.

Place attachment clutch in “DISENGAGED” position.

Turn ignition key to “STOP” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 15)

Mower will be easier to remove from the right side of trac- tor.

Place attachment clutch in “DISENGAGED” position.

Move attachment lift lever forward to lower mower to its lowest position.

Roll belt off engine pulley.

Remove small retainer spring, and remove clutch spring off pulley bolt.

Remove large retainer spring, slide collar off and push housing guide out of bracket.

Disconnect anti-swaybar from chassis bracket by re- moving retainer spring.

Disconnect suspension arms from rear deck brackets by removing retainer springs.

Disconnect front links from deck by removing retainer springs.

Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS AND HOOK THE CLUTCH SPRING INTO SQUARE HOLE IN FRAME.

TO INSTALL MOWER (See Fig. 15)

Raise attachment lift lever to its highest position.

Slide mower under tractor with deflector shield to right side of tractor.

Lower lift lever to its lowest position.

Connect front links to mower deck and secure with retainer springs..

Connect suspension arms to rear deck brackets and secure with retainer springs.

Connect anti-swaybar to chassis bracket and secure with retainer spring.

Push clutch cable housing guide into bracket, slide col- lar onto guide and secure with large retainer spring.

Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.

Install belt onto engine pulley.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

 

SMALL RETAINER SPRING

 

 

 

 

CLUTCH SPRING

 

 

 

 

FLAT WASHER

 

 

SQUARE HOLE

SMALL RETAINER SPRING

 

SUSPENSION

ENGINE PULLEY

 

 

 

ARMS

 

 

 

 

CLUTCH SPRING

 

 

 

 

 

 

 

FRONT LINK

RETAINER SPRING

 

 

 

 

ANTI-SWAY BAR

 

 

 

 

 

 

 

 

RETAINER SPRINGS

COLLAR

 

 

 

(BOTH SIDES)

HOUSING GUIDE

LARGE RETAINER

 

 

 

SPRING

BRACKET

 

DEFLECTOR SHIELD

 

 

 

 

 

 

 

FIG. 15

19

Image 19
Contents PB18H42LT ModelII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Steering Wheel Seat Unassembled PartsSlope Sheet Before Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Using the Reverse Operation SystemTo Operate Mower See Fig Reverse Operation System ROSADD Gasoline Before Starting the EngineTo Transport See Figs Check Engine OIL LevelNing Mowing TipsPurge Transmission Automatic Transmission Warm UPLubrication Chart MaintenanceBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine Muffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust BrakeFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when L5V 3E4 Limited WarrantyService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Dentretien Notes Garantie cette de exclus sont normal l’entretien et AutoriséCorrection Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Moteur EntreposageTracteur Batterie LA Replacer Reglages ET RevisionCarburateur LE Régler Pour 27 et 26 .Fig les VoirLA DE L’ALIGNEMENT Régler Pour LA DE ENLEVEMENT/REMPLACEMENTRossage AVANT/CAR Roues DES ConvergenceTransmission DE Mentnetraî Fig la Voir’EN Courroie LA Remplacer Pour Frein LE Régler ET Contrôler PourTondeuse DE Lame DE MENTNETRAÎD’EN Courroie Acer Rempl Pour15 .FIG Tondeuse DE Boîtier LE Niveler PourLautre À Côté DUN Réglage Moteur EntretienTrapézoïdales Courroies Sionmistrans LA DE Moteur FluideTransmission LA DE Refroidissement Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Recommandations LESGénérales Lubrification DE TableauQueti UtilisationTondre DE Conseils Transmission LA PurgerMoteur LE Démarrer DE Avant Pentes LES Dans Utiliser Pour Et 4 .Fig les VoirEN Fonctionnement DE Système Tracteur LE Transporter PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourTeurtrac Votre Utiliser Comment Fig la Voir Arrêter PourLSW02838 ’EMBRAYAGE NI DE EST Tondeuse LA SI Vérifier MontagePA LA DE Tracteur LE Retirer Pour Toncar Fig la Voir Siège LE InstallerDU Tracteur LE Sortir Pour Palette LASiège Direction de Volant Montées NON PiécesPente-Guide ClésClient DU Responsabilités SommaireProduit DE Spécifications Général Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils TESPEN LES Dans Fonctionnement Général FonctionnementAUX Imprimé ModèleAvertissement

PB175H42LT specifications

The Poulan PB175H42LT is a robust lawn tractor designed for homeowners seeking an efficient and reliable solution for lawn maintenance. With a focus on power, comfort, and versatility, this model stands out as a great option for handling a variety of mowing tasks.

One of the key features of the PB175H42LT is its powerful 17.5 HP Briggs & Stratton engine. This engine offers reliable starting and performance, making it suitable for tackling both small and large yards. The automatic hydrostatic transmission enhances the driving experience by providing a smooth and effortless change of speed without the need for shifting gears. This means users can focus more on mowing rather than managing complicated controls.

The 42-inch cutting deck of the Poulan PB175H42LT is designed for efficiency and precision. With its three-blade system, it delivers an even and clean cut, reducing the number of passes needed to achieve a well-manicured lawn. The deck is also adjustable, allowing users to set their desired cutting height between 1.5 to 4 inches, catering to various grass types and preferences.

Comfort is a priority with the PB175H42LT, which features a comfortable high back seat and easy-to-reach controls. The tractor's design also includes a tight turning radius, making it easy to navigate around flower beds and trees. Additionally, the generous legroom and ergonomic layout ensure that users can operate the tractor for extended periods without discomfort.

The Poulan PB175H42LT incorporates several technologies that enhance its functionality. For example, the Easy Start technology allows for quick engine ignition, so users can get started with their mowing tasks without delay. The integrated mulching capability provides added versatility, enabling homeowners to fertilize their lawns naturally while maintaining a tidy appearance.

Durability is another hallmark of the Poulan brand, and the PB175H42LT is built to last. Its heavy-duty construction ensures that the tractor can withstand regular use and varying conditions, making it a solid investment for any homeowner.

In summary, the Poulan PB175H42LT is a well-designed lawn tractor that combines power, comfort, and advanced features. Its reliable engine, adjustable cutting deck, and user-friendly controls make it an excellent choice for maintaining a beautiful lawn with ease. Whether tackling tough weeds or managing routine mowing, this model delivers the performance and reliability homeowners need.