Poulan PB175H42LT manual To Check and Adjust Brake See Fig, To Replace Motion Drive Belt See Fig

Page 21

SERVICE AND ADJUSTMENTS

TO CHECK AND ADJUST BRAKE (See Fig. 21)

Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle.

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted.

TO CHECK BRAKE

•Park tractor on a level, dry concrete or paved surface, depress clutch/brake pedal all the way down and en- gage parking brake.

•Disengage transmission by placing freewhel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, the brake needs to be adjusted or the pads need to be replaced.

TO ADJUST BRAKE

•Depress clutch/brake pedal all the way down and engage parking brake.

•Measure distance between brake operating arm and nut “A” on brake rod.

•If distance is other than 1-9/16", loosen jam nut and turn nut “A” until distance becomes 1-9/16". Retighten jam nut against nut “A”.

•Engage transmission by placing freewheel control in “transmission engaged” position.

•Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than five (5) feet in highest gear, further maintenance is necessary. Replace brake pads or contact a qualified service center.

WITH PARKING BRAKE “ENGAGED”

NUT “A”

1-9/16”

JAM NUT

 

OPERATING

ARM

01513

DO NOT TOUCH THIS NUT. IF FURTHER BRAKE ADJUST- MENT IS NECESSARY CONTACT YOUR NEAREST AUTHO- RIZED SERVICE CENTER/DEPARTMENT

FIG. 21

TO REPLACE MOTION DRIVE BELT (See Fig. 22)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

•Remove mower (See “TO REMOVE MOWER” in this section of manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

•Remove belt from stationary idler and clutching idler.

•Remove belt downward from around engine pulley.

•Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades.

•Remove belt from center span keeper and pull belt away from tractor.

BELT INSTALLATION -

•Carefully work new belt down around transmission cooling fan and onto the input pulley.

•Slide belt into the center span keeper.

•Pull belt toward front of tractor and roll around the top groove of engine pulley.

•Install belt through stationary idler and clutching idler.

•Make sure belt is in all pulley grooves and inside all belt guides and keepers.

•Install mower (See “TO INSTALL MOWER” in this section of manual).

ENGINE

PULLEY

CLUTCHING

IDLER

STATIONARY

IDLER

TRANSMISSION

 

INPUT PULLEY

CENTER SPAN

 

KEEPER

FIG. 22

TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT (See Fig. 23)

The motion control lever has been preset at the factory and adjustment should not be necessary.

•Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.

•Start engine and move motion control lever until tractor does not move forward or backward.

•Hold motion control lever in that position and turn engine

21 off.

Page 20 Page 22
Image 21
Page 20 Page 22
Contents PB18H42LT ModelSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Steering Wheel SeatSlope Sheet Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsTo Transport See Figs Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP NingLubrication Chart MaintenanceTractor Blade Removal See FigTo Sharpen Blade See Fig Engine Clean AIR Screen CleaningAIR Filter MufflerTo Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigBelt Installation To Replace Mower Blade Drive Belt See FigBelt Removal Transaxle Motion Control Lever Neutral Adjustment See Fig To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when L5V 3E4 Limited WarrantyService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Dentretien Notes Garantie cette de exclus sont normal l’entretien et AutoriséCorrection Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur Carburateur LE Régler Pour Reglages ET Revision27 et 26 .Fig les Voir Batterie LA ReplacerRossage LA DE ENLEVEMENT/REMPLACEMENTAVANT/CAR Roues DES Convergence LA DE L’ALIGNEMENT Régler Pour’EN Courroie LA Remplacer Pour Fig la VoirFrein LE Régler ET Contrôler Pour Transmission DE MentnetraîTondeuse DE Lame DE MENTNETRAÎD’EN Courroie Acer Rempl PourTondeuse DE Boîtier LE Niveler Pour 15 .FIGLautre À Côté DUN Réglage Moteur EntretienTransmission LA DE Refroidissement Sionmistrans LA DE Moteur FluideFig la Voir Lame LA Affiler Trapézoïdales CourroiesEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverGénérales Recommandations LESLubrification DE Tableau Utilisation Chaque AvantTondre DE Conseils UtilisationTransmission LA Purger QuetiMoteur LE Démarrer DE Avant EN Fonctionnement DE Système Et 4 .Fig les VoirTracteur LE Transporter Pour Pentes LES Dans Utiliser PourTeurtrac Votre Utiliser Comment GAZ DES Commande LA Utiliser PourFig la Voir Arrêter Pour Fig la Voir Mentnetionsta DE Frein LE Engager PourLSW02838 ’EMBRAYAGE NI DE EST Tondeuse LA SI Vérifier MontagePA LA DE Tracteur LE Retirer Pour DU Tracteur LE Sortir Pour Fig la Voir Siège LE InstallerPalette LA ToncarPente-Guide Montées NON PiécesClés Siège Direction de VolantSommaire Client DU ResponsabilitésProduit DE Spécifications Remorquage EntretienEnfants Général EntretienPEN LES Dans Fonctionnement TESGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsModèle AUX ImpriméAvertissement

PB175H42LT specifications

The Poulan PB175H42LT is a robust lawn tractor designed for homeowners seeking an efficient and reliable solution for lawn maintenance. With a focus on power, comfort, and versatility, this model stands out as a great option for handling a variety of mowing tasks.

One of the key features of the PB175H42LT is its powerful 17.5 HP Briggs & Stratton engine. This engine offers reliable starting and performance, making it suitable for tackling both small and large yards. The automatic hydrostatic transmission enhances the driving experience by providing a smooth and effortless change of speed without the need for shifting gears. This means users can focus more on mowing rather than managing complicated controls.

The 42-inch cutting deck of the Poulan PB175H42LT is designed for efficiency and precision. With its three-blade system, it delivers an even and clean cut, reducing the number of passes needed to achieve a well-manicured lawn. The deck is also adjustable, allowing users to set their desired cutting height between 1.5 to 4 inches, catering to various grass types and preferences.

Comfort is a priority with the PB175H42LT, which features a comfortable high back seat and easy-to-reach controls. The tractor's design also includes a tight turning radius, making it easy to navigate around flower beds and trees. Additionally, the generous legroom and ergonomic layout ensure that users can operate the tractor for extended periods without discomfort.

The Poulan PB175H42LT incorporates several technologies that enhance its functionality. For example, the Easy Start technology allows for quick engine ignition, so users can get started with their mowing tasks without delay. The integrated mulching capability provides added versatility, enabling homeowners to fertilize their lawns naturally while maintaining a tidy appearance.

Durability is another hallmark of the Poulan brand, and the PB175H42LT is built to last. Its heavy-duty construction ensures that the tractor can withstand regular use and varying conditions, making it a solid investment for any homeowner.

In summary, the Poulan PB175H42LT is a well-designed lawn tractor that combines power, comfort, and advanced features. Its reliable engine, adjustable cutting deck, and user-friendly controls make it an excellent choice for maintaining a beautiful lawn with ease. Whether tackling tough weeds or managing routine mowing, this model delivers the performance and reliability homeowners need.
Top Page Image Contents