Poulan PO16542B manual Mowing Tips, ADD Gasoline, To Start Engine See Fig

Page 13

OPERATION

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to sepa- ration and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 5)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place gear shift lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the tempera- ture.

•The attachments can also be used during the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

MOWING TIPS

•Tire chains cannot be used when the mower housing is attached to tractor.

•Mower should be properly leveled for best mowing performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

•The left hand side of mower should be used for trimming.

•Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the machine. This will result in a more even distribution of clippings and more uniform cutting.

•When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig. 8).

•If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

•Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

•Always operate engine at full throttle when mowing to assure better mowing performance and proper dis- charge of material. Regulate ground speed by selecting a low enough gear to give the mower cutting perfor- mance as well as the quality of cut desired.

•When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

FIG. 8

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Model NO. PO16542B IV. Service Safety RulesGeneral Operation II. Slope OperationSafe Operation Practices for Ride-On Mowers Safety RulesTable of Contents Steering Wheel Seat Unassembled PartsKeys Slope SheetTools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CAR- TONLower seat into operating position and sit on seat Install Seat See FigCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Before Starting the EngineTo Transport Towing Carts and Other ATTACH- MentsADD Gasoline Mowing TipsTo Start Engine See Fig Service Dates Lubrication ChartCustomer Responsibilities General RecommendationsBrake Operation TractorTires Operator Presence SystemEngine BatteryBelts Transaxle CoolingTo Service PRE-CLEANER Clean AIR ScreenTo Service Cartridge Engine Cooling Fins See FigMuffler CleaningSpark Plugs IN-LINE Fuel Filter See FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingBelt Installation To Adjust Brake See FigTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigReplacing Battery See Figs To Adjust Steering Wheel AlignmentFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTo Replace Headlight Bulb To Adjust CarburetorInterlocks and Relays To Replace FuseOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsWhen operator leaves Tractor - Model Number PO16542B, Product no 56 SchematicElectrical KEY Part Description Chassis and Enclosures Saddle Slkscr Flat Lt 6 Sp Drive Transaxle Peerless Model 206-545C Steering Assembly KEY Part NO. NO. Description Engine 148315 Seat Assembly Wheels & Tires DecalsMower Lift 159460 Mower Deck Repair Parts Service Notes Limited Warranty C U M SEH Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation

PO16542B specifications

The Poulan PO16542B is a robust and versatile lawn mower designed for homeowners and landscapers seeking reliability and ease of use. This model stands out in the crowded market of outdoor power equipment due to its thoughtful engineering and practical features.

Equipped with a 42-inch cutting deck, the PO16542B ensures that users can cover large areas effectively, reducing the need for multiple passes. This size strikes a balance between maneuverability and efficiency, making it ideal for medium-sized yards. The cutting deck is adjustable, allowing users to select from various cutting heights, which enables them to achieve the desired finish for their lawn.

One of the key technologies incorporated into the PO16542B is its powerful 16.5 HP Briggs & Stratton engine. Known for its reliability, this engine provides ample power to tackle tough grass and uneven terrain. The engine's design allows for easy starting, which is a significant convenience for users eager to get their mowing tasks done quickly.

Another notable feature of the Poulan PO16542B is its easy-to-use transmission system. The lawn mower includes a hydrostatic transmission that provides smooth and effortless speed adjustments. This ensures that users can control their mowing speed precisely, making for a more tailored mowing experience. Whether navigating around flower beds or cutting in straight lines across open lawns, this feature enhances maneuverability.

Comfort is also prioritised in the design of the PO16542B. The mower features an ergonomically designed seat that provides adequate support during long mowing sessions. Coupled with easy-access controls positioned conveniently at hand, it promotes user-friendly operation, reducing fatigue over extended periods.

Additionally, the Poulan PO16542B is built with durability in mind. Its sturdy construction and high-quality materials ensure that the mower can withstand the rigors of regular use. This longevity is complemented by the ease of maintenance, with features such as easy-access oil and filter changes.

Overall, the Poulan PO16542B presents a compelling package for those looking for a reliable, efficient, and comfortable mower. With its combination of power, adaptability, and user-centric design, it stands out as a formidable choice for lawn care, making the chore of mowing not just manageable, but enjoyable.
Top Page Image Contents