Poulan PPH23B48 manual Tractor, Blade Care, Blade Removal See Fig, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

Maintain proper air pressure in all tires (See the sides of tires for proper PSI).

Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OPERATION SYSTEM (ROS) (See Fig. 14)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 14

15

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor. Using a blade not approved by the manu- facturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 15)

Raisemowertohighestpositiontoallowaccesstoblades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

Remove blade bolt by turning counterclockwise.

Install new or resharpened blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT:TOENSUREPROPERASSEMBLY,CENTERHOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT HEAT TREATED.

MANDREL ASSEMBLY

 

BLADE

 

BLADE BOLT

STAR

(SPECIAL)

CENTER HOLE

Fig. 15

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

Keep battery and terminals clean.

Keep battery bolts tight.

Keep small vent holes open.

Recharge at 6-10 amperes for 1 hour.

NOTE:Theoriginalequipmentbatteryonyourtractorismain- tenance free. Do not attempt to open or remove caps or cov- ers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

Raise seat/hood.

Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

Rinse the battery with plain water and dry.

Clean terminals and battery cable ends with wire brush until bright.

Coat terminals with grease or petroleum jelly.

Reinstall battery (See “REPLACING BATTERY" in the SERVICEANDADJUSTMENTSsectionofthismanual).

Image 15
Contents PPH23B48 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents To Remove Tractor from Carton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorAttachment Clutch Switch Disengaged Engaged To SET Parking Brake See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Operate on Hills Service REMINDER/HOUR MeterTo Operate Mower Reverse Operation System ROSTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsMaintenance Lubrication ChartPowdered Graphite Type Lubricant Sparingly Blade Removal See Fig BatteryTractor Blade CareEngine Cleaning Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig First Install ANTI-SWAY BAR S Engage belt tension rod K on locking bracket L M FTurn nut right Turn nut left To raise mower Visual SIDE-TO-SIDE Adjustment See FigPrecision SIDE-TO-SIDE Adjustment See Fig To Level MowerTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Replace Motion Drive Belt See Fig To Remove Wheel for Repairs See Fig To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingEngine continues To run when operBattery will not Fires when turnService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés MAX ’ENTRETIEN Remarques Correction Cause Problème Dépannage DE GuidePuissance de Entreposage Carburateur LE Régler Pour Starter DU Commande LA Régler PourReglages ET Revision MoteurFig la Voir Faible Rietebat RossageAVANT/CAR Roues DES Convergence LA DE L’ALIGNEMENT Régler PourFreins LES Vérifier Pour LA DE Courroie LA Remplacer Pour Fig la Voir D’ENTRAÎNEMENTCourroie Acer Rempl Pour Fig la Voir Tondeuse LA DE Lame30 .Fig Tondeuse LA Niveau LE Ajuster Pour32 .Fig 31 .Fig26 .Fig Avant l’embrayage de poulie la sur courroie la Installez28 .Fig 27 .Fig22 .FIG 25 .FIG24 .FIG 23 .FIGStationnement de frein le actionnez et niveau Tondeuse LA Installer28 19 .Figs les Voir 18 19 .Fig 20 .FigEntretien Transmission LA DE Entretien Sionmistrans LA DE Moteur FluideFig La Voir Coupe DE Plateau DU Lavage DE Raccord LubrificationFrein DU Fonctionnement Fig la Voir Lame LA EnleverLames DES Entretien PneusLubrification DE Tableau Utilisation Chaque Avant13 .Fig Avant ET Réinstallation LA Après Purgée ÊtreUtilisation Transmission LA PurgerMoteur DU D’HUILE Niveau LE Vérifier ’ESSENCE Réservoir LE RemplirPentes LES Dans Utiliser Pour Accessoires Autres ET Charrettes DES Remorquer PourROS Arrière Marche EN Fonctionnement DE Système Tracteur LE Transporter PourTondeuse LA Utiliser Pour Tondeuse DE Lames LES Arrêter PourJauge DE Roues LES Régler Pour Fig la Voir J Vitesse DE Régulateur LE Utiliser CommentMoteur GAZ DES Commande LA Utiliser PourFig la Voir Arrêter Pour Fig la Voir Mentnetionsta DE Frein LE Embrayée Pour’ACCESSOIRE D’EMBRAYAGE Interrupteur E Propriété la de lendommagement et/ou sérieuses NI DE EST Tondeuse LA SI Vérifier MontageDU Tracteur LE Sortir Pour Montées NON PiécesProduit DE Spécifications UtilisationMontage Client DU ResponsabilitésGénéral Entretien EnfantsEntretien RemorquageGénéral Fonctionnement AvertissementPentes LES Dans Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAvertissement U the in Printed SR 09.06.02

PPH23B48 specifications

The Poulan PPH23B48 is a versatile and powerful lawn tractor designed for homeowners who demand efficiency and comfort in their outdoor mowing tasks. Engineered to handle a variety of yard sizes, this model boasts a reliable Briggs & Stratton engine that delivers robust performance for tackling grass and terrain with ease.

One of the standout features of the PPH23B48 is its 48-inch cutting deck. This wide cutting path allows for quicker mowing sessions, enabling users to cover more ground in less time. The deck is crafted from durable materials to withstand the rigors of frequent use while providing clean and even cuts. The adjustable cutting height feature offers six positions, allowing operators to customize grass length to suit their preferences and environmental conditions.

The Poulan PPH23B48 is equipped with an innovative hydrostatic transmission system, which contributes to a smoother driving experience. This technology eliminates the need for manual shifting, allowing riders to easily control their speed without the hassle of changing gears. This feature is especially beneficial for navigating various terrains, as it enables seamless transitions from flat lawns to inclines.

Comfort is paramount in the design of the PPH23B48. The ergonomic seat is designed for prolong use, reducing fatigue during longer mowing sessions. With a user-friendly dashboard, operators can quickly monitor fuel levels, engine performance, and operational settings, ensuring efficient management of mowing tasks.

Furthermore, Poulan has incorporated a tight turning radius into this model, which enhances maneuverability around obstacles like trees and flower beds. The easy-to-use steering wheel provides precision control, making it simple for users to navigate their yards effortlessly.

The PPH23B48 is also equipped with a mulching capability, which allows users to recycle grass clippings back into the lawn. This eco-friendly feature not only reduces waste but also adds valuable nutrients back into the soil, promoting a healthier lawn.

In summary, the Poulan PPH23B48 combines power, efficiency, and user-centric design to create a lawn tractor that meets the needs of various homeowners. Its thoughtful features and advanced technologies make outdoor mowing not just a chore, but a manageable and enjoyable task.