Poulan PP16H36RB, 96061015703, 960 61 01-57 owner manual Cleaning

Page 21

MAINTENANCE

•Unlock drain valve by pushing inward and turning counterclockwise.

•To open, pull out on the drain valve.

•After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown.

•Remove the drain tube and replace the cap onto to the bottom fitting of the drain valve.

•Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not overfill. For approximate capacity see “PRODUCT SPECIFICATIONS” section of this man- ual.

•Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. Keep oil at “FULL” line on dipstick. Tighten cap onto the tube securely when finished.

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers. See engine manual.

AIR FILTER

Your engine will not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every 50 hours of operation or every season, whichever occurs first. See engine manual.

CLEAN AIR INTAKE/COOLING AREAS

To insure proper cooling, make sure the grass screen, cooling fins, and other external surfaces of the engine are kept clean at all times.

Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds. Clean the cooling fins and external surfaces as necessary. Make sure the cooling shrouds are reinstalled.

NOTE: Operating the engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will cause engine damage due to overheating.

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or dam- age.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in “PRODUCT SPECIFICATIONS” section of this manual.

IN-LINE FUEL FILTER (See Fig. 23)

The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carburetor, replacement is required.

•With engine cool, remove filter and plug fuel line sec- tions.

•Place new fuel filter in position in fuel line with arrow pointing towards carburetor.

•Be sure there are no fuel line leaks and clamps are properly positioned.

•Immediately wipe up any spilled gasoline.

CLAMP

CLAMP

FUEL

FILTER

Fig. 23

CLEANING

•Clean engine, battery, seat, finish, etc. of all foreign matter.

•Keep finished surfaces and wheels free of all gasoline, oil, etc.

•Protect painted surfaces with automotive type wax.

We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and trans- mission are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves and trash from tractor and mower.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents PP16H36RB Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents 3EAT Unassembled PartsAttery +EYTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Fig To Assemble Bagger See Figs A-5C To Install Bagger Components to Tractor See Figs A-4DHorizontal Adjustment Bagger Adjustment SeeVertical Adjustment To Assemble and Install Mulcher Plug See FigCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsBefore Starting the Engine Service REMINDER/HOUR MeterCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsMulching Mowing Tips NingTo Dump Bagger See To Convert Mower See FigBagging see Fig Lubrication Chart MaintenanceStar Pattern Blade See Fig TractorBlade Care See Fig Check Operator Presence SystemEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigBelt Installation To Replace Mower Blade Drive Belt See FigBelt Removal Transaxle Motion Control Lever Neutral ADJUSTMENTSee Fig Transmission REMOVAL/REPLACEMENTTo Check Brake To Replace Motion Drive Belt See FigTo Adjust Throttle Control Cable To Adjust Steering Wheel AlignmentTo Adjust Carburetor Front Wheel TOE-IN/CAMBEROther StorageFuel System Engine OILTroubleshooting Points With attachment clutch Schematic Repair PartsElectrical 532 17 KEY Part DescriptionChassis and Enclosures 532 42 532 40Drive 817 49 Steering Assembly 532 19 Steering Wheel Seat Assembly Wheels & Tires DecalsEngine Tank Fuel Mower 532 19 532 17 Link Front Mower LiftBagger 532 16 52-49 Tube Handle Bagger CRD532 41 Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation

960 61 01-57, 96061015703, PP16H36RB specifications

The Poulan PP16H36RB, model number 96061015703, is a robust and versatile lawn mower designed to tackle various landscape maintenance tasks with ease. It embodies a powerful combination of features and technologies that cater to both novice and experienced users, making lawn care an enjoyable and efficient chore.

At the heart of the Poulan PP16H36RB is a reliable 16 horsepower Briggs & Stratton engine, ensuring ample power to navigate tough terrain and handle thick grass effortlessly. The engine is designed for efficiency and longevity, providing smooth operation and requiring minimal maintenance. This engine is paired with a user-friendly electric start feature, allowing for quick and hassle-free ignition.

One of the standout features of this model is its wide cutting deck, which measures 36 inches. This generous width enables the mower to cover more ground in a single pass, significantly reducing mowing time. The cutting deck is equipped with durable, sharp blades that provide a clean, precise cut, promoting a healthy lawn. The mower also offers multiple cutting height adjustments, ranging from 1.5 to 4 inches, allowing users to customize their mowing to suit different grass types and personal preferences.

The Poulan PP16H36RB is designed for comfort and control, featuring an ergonomic, fully adjustable seat that supports the user during long mowing sessions. The mower is equipped with a smooth hydrostatic transmission that allows for seamless speed control. This feature enhances maneuverability around obstacles such as trees and flowerbeds, ensuring that users can maintain their lawns without missing a spot.

Safety is also a priority in the design of the PP16H36RB. The mower includes essential safety features such as automatic blade disengagement, which stops the blades when the user leaves the seat, preventing accidents. The sturdy frame and reliable construction ensure that users can navigate rough terrain without compromising stability or safety.

In conclusion, the Poulan PP16H36RB, with its powerful engine, wide cutting deck, and user-friendly features, stands out as a dependable choice for anyone looking to maintain their yard effortlessly. It combines comfort, efficiency, and safety, making it an excellent investment for achieving a beautifully manicured lawn. With the Poulan PP16H36RB, lawn care becomes less of a chore and more of a pleasure.
Top Page Image Contents