Poulan 96061015703 Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 22

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

Depress clutch/brake pedal fully and set parking brake.

Place motion control lever in neutral (N) position.

Place attachment clutch in “DISENGAGED” position.

Turn ignition key to “STOP” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 24)

Mower will be easier to remove from the right side of tractor.

Place attachment clutch control in “DISENGAGED” position.

Move attachment lift lever forward to lower mower to its lowest position.

Roll belt off clutch pulley.

Disconnect anti-sway bar from chassis bracket by removing retainer spring.

Disconnect suspension arms from rear deck brackets by removing retainer springs.

Disconnect front links from deck by removing retainer springs.

Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS.

TO INSTALL MOWER (See Fig. 24)

Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage parking brake.

Slide mower under tractor.

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

Install belt into clutch pulley groove.

Install left front link into the left hand front mower bracket (retain with single loop retainer springs as shown).

Slide right side of mower back and install right front link into right hand front mower bracket (retain with single loop retainer springs).

Place the suspension arms on mower pins, if necessary, rock and raise front of mower to align mower pins with the holes in suspension arms. Retain with double loop retainer spring, loop down as shown.

Connect anti-sway bar to chassis bracket under left footrest and retain with double loop retainer spring.

Raise deck to highest position.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Makesuretiresareproperlyinflated(See“PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 25 and 26)

Raise mower to its highest position.

At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

If adjustment is necessary, make adjustment on one side of mower only.

To raise one side of mower, tighten lift link adjustment nut on that side.

To lower one side of mower, loosen lift link adjustment nut on that side.

RETAINER SPRING

SUSPENTION

ARMS

CLUTCH PULLEY

FRONT LINKS

 

RETAINER

RETAINER

SPRINGS

 

SPRING

 

ANTI SWAY

BAR

5 0237

Fig. 24

22

Image 22
Contents PP16H36RB General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Attery Unassembled Parts3EAT +EYTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidInstall Seat See Fig To Install Bagger Components to Tractor See Figs A-4D To Assemble Bagger See Figs A-5CVertical Adjustment Bagger Adjustment SeeHorizontal Adjustment To Assemble and Install Mulcher Plug See FigCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS Using the Reverse Operation SystemTo Operate Mower See Fig To Operate on HillsCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine ADD GasolineMulching Mowing Tips Mowing TipsPurge Transmission NingTo Convert Mower See Fig To Dump Bagger SeeBagging see Fig Maintenance Lubrication ChartBlade Care See Fig TractorStar Pattern Blade See Fig Check Operator Presence SystemEngine Cleaning To Level Mower Housing Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Check Brake Transmission REMOVAL/REPLACEMENTTransaxle Motion Control Lever Neutral ADJUSTMENTSee Fig To Replace Motion Drive Belt See FigTo Adjust Carburetor To Adjust Steering Wheel AlignmentTo Adjust Throttle Control Cable Front Wheel TOE-IN/CAMBERFuel System StorageOther Engine OILTroubleshooting Points With attachment clutch Repair Parts SchematicElectrical KEY Part Description 532 17Chassis and Enclosures 532 40 532 42Drive 817 49 Steering Assembly 532 19 Steering Wheel Seat Assembly Decals Wheels & TiresEngine Tank Fuel Mower 532 19 Mower Lift 532 17 Link Front532 16 52-49 Tube Handle Bagger CRD Bagger532 41 Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX

960 61 01-57, 96061015703, PP16H36RB specifications

The Poulan PP16H36RB, model number 96061015703, is a robust and versatile lawn mower designed to tackle various landscape maintenance tasks with ease. It embodies a powerful combination of features and technologies that cater to both novice and experienced users, making lawn care an enjoyable and efficient chore.

At the heart of the Poulan PP16H36RB is a reliable 16 horsepower Briggs & Stratton engine, ensuring ample power to navigate tough terrain and handle thick grass effortlessly. The engine is designed for efficiency and longevity, providing smooth operation and requiring minimal maintenance. This engine is paired with a user-friendly electric start feature, allowing for quick and hassle-free ignition.

One of the standout features of this model is its wide cutting deck, which measures 36 inches. This generous width enables the mower to cover more ground in a single pass, significantly reducing mowing time. The cutting deck is equipped with durable, sharp blades that provide a clean, precise cut, promoting a healthy lawn. The mower also offers multiple cutting height adjustments, ranging from 1.5 to 4 inches, allowing users to customize their mowing to suit different grass types and personal preferences.

The Poulan PP16H36RB is designed for comfort and control, featuring an ergonomic, fully adjustable seat that supports the user during long mowing sessions. The mower is equipped with a smooth hydrostatic transmission that allows for seamless speed control. This feature enhances maneuverability around obstacles such as trees and flowerbeds, ensuring that users can maintain their lawns without missing a spot.

Safety is also a priority in the design of the PP16H36RB. The mower includes essential safety features such as automatic blade disengagement, which stops the blades when the user leaves the seat, preventing accidents. The sturdy frame and reliable construction ensure that users can navigate rough terrain without compromising stability or safety.

In conclusion, the Poulan PP16H36RB, with its powerful engine, wide cutting deck, and user-friendly features, stands out as a dependable choice for anyone looking to maintain their yard effortlessly. It combines comfort, efficiency, and safety, making it an excellent investment for achieving a beautifully manicured lawn. With the Poulan PP16H36RB, lawn care becomes less of a chore and more of a pleasure.