Poulan PO14542E To Level Mower Housing, To Replace Mower Blade Drive Belt See Fig, Belt Removal

Page 20

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PROD- UCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 17 and 18)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Three full turns of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

BOTTOM EDGE

OF MOWER

OF MOWER

TO GROUND

TO GROUND

“A”

“A”

 

GROUND LINE

FIG. 17

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

"D"

"D"

FIG. 19

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT "F"

NUT "E"

TRUNNION

FRONT LINKS

SUSPENSION ARM

LIFT LINK

ADJUSTMENT

NUT

FIG. 18

FRONT-TO-BACK ADJUSTMENT (See Figs. 19 and 20)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO- SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

• Before making any necessary adjustments, check that both front links are equal in length.

• If links are not equal in length, adjust one link to same length as other link.

• To lower front of mower loosen nut “E” on both front links

FIG. 20

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 21)

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

•Remove mower from tractor (See “TO REMOVE MOWER” in this section of this manual).

•Work belt off both mandrel pulleys and idler pulleys.

•Pull belt away from mower.

BELT INSTALLATION -

•Install new belt in reverse order of removal.

•Make sure belt is in all pulley grooves and inside all belt guides.

•Install mower in reverse order of removal instructions.

MANDREL

IDLER

PULLEY

PULLEYS

 

MANDREL

PULLEY

an equal number of turns.

20

FIG. 21

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model NO. PO14542E Safety Rules IV. ServiceGeneral Operation II. Slope OperationTable of Contents Product Specifications Customer ResponsibilitiesUnassembled Parts Steering Wheel SeatKeys Slope SheetAssembly Tools Required for AssemblyTo Remove Tractor from CAR- TON Before Removing Tractor from SkidInstall Seat See Fig HOW to SET UP Your TractorCheck Battery See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Operate on HillsTo Transport Towing Carts and Other ATTACH- MentsTo Start Engine See Fig Mowing TipsADD Gasoline Lubrication Chart Service DatesCustomer Responsibilities General RecommendationsTractor Brake OperationTires Operator Presence SystemBattery EngineBelts Transaxle CoolingClean AIR Screen To Service PRE-CLEANERTo Service Cartridge Engine Cooling Fins See FigCleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigTo Remove Mower see FIG Service and AdjustmentsTo Install Mower see FIG To Level Mower Housing Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERReplacing Battery See Figs To Remove Hood and Grill Assembly See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number PO14542EElectrical 4529KEY Part Description Chassis and Enclosures Repair Parts Drive Transaxle Peerless Model 206-545C Steering Assembly KEY Part NO. NO. Description Engine KEY Part Description Seat Assembly Decals Wheels & TiresMower Lift Nut Lock w/Wsh 1/2-13 Unc Mower Deck Repair Parts Service Notes Limited Warranty C U M SEH Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX

PO14542E specifications

The Poulan PO14542E is a versatile and efficient lawn mower designed to deliver exceptional performance for homeowners who prioritize quality and reliability. With its powerful engine and user-friendly features, this mower is the ideal choice for maintaining a pristine lawn, no matter the size or terrain.

One of the standout features of the PO14542E is its robust 14.5 horsepower engine, which provides ample power for tackling dense grass and uneven terrains. This engine is designed for optimal fuel efficiency, reducing emissions while ensuring that you can complete your mowing tasks without frequent stops for refueling. The easy-starting system allows users to get the machine running quickly, making lawn care hassle-free.

The cutting deck of the Poulan PO14542E measures 42 inches, allowing for an efficient cutting width that strikes a balance between maneuverability and effective grass coverage. The sturdy deck is constructed from durable materials designed to withstand the rigors of regular use, ensuring longevity and reliability. Additionally, the mower features adjustable cutting heights, giving users the flexibility to choose the ideal length for their lawn.

Comfort and ease of use are emphasized in the design of the PO14542E. The mower is equipped with a comfortable seat, ergonomic controls, and easy-to-handle steering, making it suitable for extended mowing sessions. The adjustable speed settings allow users to match their mowing pace to the conditions of their lawn, whether tackling thick grass or navigating around obstacles.

One of the innovative technologies incorporated into the Poulan PO14542E is the automatic lubrication system, which ensures that the engine components remain well-lubricated, reducing wear and enhancing overall performance. This feature means less maintenance for users, allowing them to spend more time enjoying their lawn rather than working on their mower.

Overall, the Poulan PO14542E combines power, efficiency, and comfort, making it a top choice for those looking to maintain their lawns with ease. With its reliable engine, adjustable features, and user-friendly design, this mower stands out as a dependable tool for lawn care enthusiasts and homeowners alike. Whether you have a small backyard or a sprawling garden, the PO14542E can help you achieve a well-manicured landscape with minimal effort.
Top Page Image Contents