Assemble Filter System
1.Open the 2 latches on top of the blower transition.
2.Open the filter access door.
3.Remove the filter from the housing assembly. The filter will be reinstalled at the end of the installation process.
4.For 30" (76.2 cm) base cabinet installation only:
a.) Preinstall 2 - #8 AB x ½" black screws provided with kit into the predrilled holes in the cabinet floor next to the left side cabinet wall.
Top View of Cabinet
A
B
C
A.Left side cabinet wall
B.Predrilled holes in floor
C.
b.) Leave approximately an ¹⁄₈" (3.2 mm) gap between the bottom of the screw head and the cabinet floor.
¹⁄₈"
(3.2 mm)
c.) Place the housing assembly into the cutout in the cabinet floor aligning the slotted flange on the left side under the screw heads (A).
d.) Install 2 - #8 AB x ½" screws (B) through the round holes
in the right side of the housing and into the predrilled holes in the cabinet floor and tighten.
Top View of Cabinet
AB
A. Left side preinstalled screws
B. Right side screws
e.) Tighten the 2 - #8 AB x ½" screws on the left side (A).
For 36" (91.4 cm) base cabinet installation only:
a.) Place the housing assembly into the cutout in the cabinet floor aligning the slotted flange with predrilled holes in cabinet floor.
Top View of Cabinet
AA
A. 4 - #8 AB x ½" screws
b.) Install 4 - #8 AB x ½" screws (A) through the round holes in the housing and into the predrilled holes in the cabinet floor and tighten.
5.Attach one end of the flex duct to the blower exhaust scroll with 1 clamp.
Front View of Cabinet
A
B
C
A. Blower exhaust scroll
B.Clamp
C.Flex duct
7
